Toro 105-8400 Installation Instructions

Replacement Exhaust Pipe Kit

for Dingo 222 Compact Utility Loader (Model 22300)

Part No. 105-8400

Loose Parts

Description Qty. Use

Form No. 3329-935

Installation Instructions

Exhaust pipe, upper Exhaust pipe, lower Pipe clamps Bracket Bracket extension Carriage bolt Small lock washer Large lock washer Nut Bolt Washer

Removing the Existing Exhaust Pipe

1. Raise the loader arms and install the cylinder locks, stop

the engine, remove the key and allow the engine to cool completely.

Warning

1 1 2 1 1 1 1 1 1 1 1

Install the exhaust pipe

If the engine has been running, the muffler will be very hot and can seriously burn you if you touch it.

Allow the engine and muffler to cool completely before completing this procedure.

2. Remove and discard the bolt and washers securing the

existing exhaust pipe to the front of the engine.

3. Loosen the clamp securing the exhaust pipe to the

muffler.

4. Remove and discard the exhaust pipe and clamp.

Installing the Exhaust Pipe

1. If the clamps are not already on the exhaust pipes,

install them loosely over the pipes as shown in Figure 1.

2. Remove the upper nut from the clamp on the lower pipe

(Fig. 1).

 2003 by The Toro Company 8111 Lyndale Avenue South Bloomington, MN 55420-1196

1. Upper exhaust pipe

2. Lower exhaust pipe

3. Pipe clamps

4. Install the bracket here.

5. Bracket

6. Bracket extension

3. Install the bracket over the end of the clamp U-bolt and

secure it with the nut removed previously (Fig. 1).

4. Loosely install the bracket extension to the bracket

using a carriage bolt, small lock washer, and nut (Fig. 1).

Figure 1

7. Carriage bolt

8. Small lock washer

9. Nut

10. Bolt

11. Large lock washer

12. Washer

Printed in the USA

m–6887

5. Loosely install the upper pipe into the lower pipe

(Fig. 1).

6. Loosely install the upper pipe onto the muffler.

7. Loosely secure the bracket extension to the threaded

hole in the front of the engine using a bolt, large lock washer, and washer (Fig. 1).

8. Ensure that the exhaust pipe end is positioned in the

opening in the side of the frame.

9. Tighten the nuts on the 2 pipe clamps and other

fasteners to secure the pipe and brackets into place (Fig. 1).