Toro 105-6994 Installation Instructions

Seat Spring Kit

TimeCutter Z Riding Mowers

Part No. 105-6994

Loose Parts

Description Qty. Use

Form No. 3326-960

Installation Instructions

Screw, 5/16 x 1 in. Spring Locknut, 5/16 in. Cap

Nylon spacer, 1/2 in. Nylon spacer, 11/32 in. Shoulder bolt, 5/16 x 7/8 in. Washer, 11/32 in. Knob

1. Position the machine on a level surface. Set the

parking brake, turn the ignition off, and remove the key.

Caution

If you leave the key in the ignition switch, someone could accidently start the engine and seriously injury you or other bystanders.

Remove the key from the ignition switch before you do any maintenance.

2 2 2

Attaching the springs

2 2

Attaching the seat 2 2

8. Slide the nylon spacers (11/32 in.) between the seat

and seat support and secure the seat to the seat support with the knobs and washers (Fig. 1).

9. Lower the seat and adjust it if necessary; refer to

Positioning the Seat in the Operator’s Manual.

11 in.

(28 cm)

1-1/4 in. (3.2 cm)

2. Tip the seat forward and remove it from the seat

support. Discard the existing knobs, washers, and shoulder bolts.

3. Lower the seat support. Locate, mark, and drill 2

(11/32 in.) holes in the seat plate as shown in Figure 1.

Note: Some mowers may already have the holes drilled in the seat support.

4. Attach the springs to the seat support with the 2 screws

(5/16 x 1 in.) and locknuts (Fig. 1).

5. Attach the caps to the ends of the springs.

6. Attach the nylon spacers (1/2 in.) and shoulder bolts to

the seat.

7. Slide the shoulder bolts on the bottom of the seat into

the slots on the seat support (Fig. 1).

 2001 by The Toro Company 8111 Lyndale Avenue South Bloomington, MN 55420-1196

1 9

1. Seat support

2. Screw

3. Spring

4. Locknut

5. Cap

Figure 1

1-1/4 in. (3.2 cm)

4 5

6. Shoulder bolt

7. Nylon spacer, 1/2 in.

8. Knob

9. Washer

10. Nylon spacer, 11/32 in.