Toro 105-3195 Installation Instructions
Restraint Kit
2001 Tru Trak Sulky
Part No. 105–3195
Installation Instructions
Loose Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Form No. 3327–242
Spacer
Small Washer
Lanyard
Large Washer, 1/2 in.
Lock Nut, 5/16 in.
Bolt, 5/16 x 1–1/4 in.
2
2
2
Installing the lanyard
2
2
2
Cable 1 Installing the Cable
Important The following instructions replace
Installing the Transport Hooks in your Tru Trak Sulky
6
manual.
Note: Do not use the transport hooks for the sulky.
Installing the Lanyard
1. From the back bend in the side support, mark the
2
5
location of the holes (Fig. 1). The center hole must be
4–1/4 in. from the bend and centered vertically. Mark
two holes, one inch on each side of the center hole
(Fig. 1).
m–5691
4
2. Drill 11/32 in. holes at the three marked locations
(Fig. 1).
2001 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
1
2
1. Sulky assembly
2. Side support
3. Bend in side support
1
3
6
m–5690
Figure 1
4. 4–1/4 in. (102 mm)
5. 1 in. (26 mm)
6. 11/32 in. hole
All Rights Reserved
Printed in the USA
3. Install the nut (5/16 in.), small washer, spacer, lanyard
and bolt (5/16 x 1–1/4 in.) (Fig. 3).
5
2
4
3
1
m–5693
Figure 2
1. Bolt, 5/16 x 1–1/4 in.
2. Small Washer
3. Lanyard
4. Spacer
5. Locknut, 5/16 in.
4. Raise the sulky and position the lanyard loop until it is
in a clear location on the pulley guard, both on the
outside and inside of the guard (Fig. 3).
8. Install the shoulder bolt, washer, lanyard and locknut
(5/16 in.) to the pulley guard (Fig. 4).
Note: When the lanyard is attached to the machine, it
must not be able to be removed (Fig. 4).
3
5
4
2
1
m–5689
Figure 4
1. Shoulder bolt
2. Large Washer
3. Pulley guard
4. Locknut, 5/16 in.
5. Lanyard
5. If a hole does not exist in or near this location, mark
the location of the lanyard loop.
Important The sulky must be at least 1-1/2 in.
(3.8 cm) from any contact point such as the machine
handle or the gear shift lever (when pushed to the right
and left) on gear drive machines.
6. Drill a 9/32 in. hole at the marked location.
7. Remove the lanyard from the sulky assembly.
3
2
4
4
9. Raise the sulky assembly and attach the lanyard.
Note: The sulky can be raised or lowered by using the
three different holes in the sulky side support (Fig. 1).
10.Repeat these steps on the opposite sulky assembly.
1
1. Lanyard
2. Sulky assembly
m–5688
Figure 3
3. Mark location
4. Pulley guard
2
Loading...