Toro 105-1669 Installation Instructions
Suspension Seat Kit
Z300 Series Z Master
Part No. 105-1669
Loose Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Installation Instructions
Form No. 3328–205 Rev A
Suspension Seat
Spacer blocks
Bolts
Nuts
Lock washer
No loose parts for this section Connecting the wire harness
1
4
4
4
4
Installing the seat
Removing the Existing Seat
1. Tip seat forward and disconnect the wire connector
from the seat switch.
2. Remove the 4 bolts holding the existing seat to the seat
pan.
3. Remove the existing seat.
1
Installing the Seat
1. Remove the bolt, spacer, lock washer, and nut from the
bottom of the seat (Fig. 1).
2
4
6
2. Position the spacer blocks and seat onto the seat pan
(Fig. 1).
3. Install the bolts up into the seat pan, spacer blocks, and
the seat (Fig. 1).
4. While holding the bolts, secure the seat with lock
washers and nuts (Fig. 1).
2002 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
3
1. Seat
2. Spacer blocks
3. Seat pan
1
5
m–6284
Figure 1
4. Nut
5. Bolt
6. Lock washer
All Rights Reserved
Printed in the USA
Installing the Wire Harness
Operating the Seat
1. Locate the existing traction unit wire harness connector
that was connected to the old seat switch.
2. Cut the connector off the existing traction unit wire
harness (Fig. 2).
1
3
2
m–6286
Figure 2
1. Old traction unit wire
harness
2. Connector on old harness
3. Cut connector off
1. Rotate the seat cushion handle either direction to get the
desired suspension (Fig. 4).
2. Use the seat suspension indicator for finding and
helping remember correct seat suspension (Fig. 4).
1
2
3. Strip approximately 3/8 inch of insulation form the end
of each harness wire (Fig. 3).
4. Plug the two single wires of the old wire harness into
the 2 connectors from the new seat switch (Fig. 3).
5. Crimp the connectors to secure the wires.
4
2
3
1
m–6287
Figure 3
1. New seat
2. Wires from existing
traction unit harness
3. Connector from new seat
4. 3/8 inch of exposed wire
3
2
1. Seat
2. Seat cushion handle
m–6285
Figure 4
3. Seat suspension indicator
2
Loading...