Toro 105-1503 Installation Instructions
Adapter Kit
2001 and Earlier 42 Snowthrower to a 2002 and Later GT
Classic Garden T ractor
Part No. 105–1503
Installation Instructions
Loose Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Crank Support 1 Replacing the Crank Support
Form No. 3327–143
Pulley
Screw
Important These instructions are to be used when
installing your snowthrower. Refer to your operator
manual for complete snowthrower installation.
Replacing the Crank Support
Note: The first step only needs to be done if crank support
is already installed.
1. Remove hairpin cotter at U-joint and slide crank
handle out of support (Fig. 1).
4
1
3
2
m–5715
1
1
Replacing the Pulley
Replacing the Pulley
Note: The first three steps only need to be done if the
pulley is already installed.
1. Remove the belt off the snowthrower pulley (Fig. 2).
2
1
3
Figure 2
1. Power take off (PT O)
pulley
2. Idler pulley
3. Belt guide
4. Snowthrower pulley
4
m–2788
Figure 1
1. Crank handle
2. Crank support
3. U-joint
4. Hairpin cotter–small
2. Install the crank handle into the new crank support.
Install crank handle into the U–joint with hairpin
cotter (Fig. 1).
2001 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
2. Remove the two screws from the pulley (Fig. 3).
3. Remove the pulley from the shaft (Fig. 3).
4. Install the new pulley onto the shaft. Make sure the
key is in place on the shaft (Fig. 3).
5. Install the two screws into the pulley (Fig. 3).
All Rights Reserved
1
Printed in the USA
Note: Make sure that one of the screws is installed on top
of the key.
4
3
2
1
m–5714
Figure 3
1. Pulley
2. Screw
3. Key
4. Drive shaft
2
Loading...