Toro 104-2685 Installation Instructions

Spool Carrier Kit

for TX Compact Utility Loaders

Model No. 104-2685

Loose Parts

Note: Use the chart below to identify parts for assembly.

Form No. 3353-873 Rev A

Installation Instructions

Description

Spool carrier

Lynch pin, rectangular retainer

Mounting tube

Bolt, 4 inch

Bolt, 2-1/2 inch

Jam nut

Secondary spool carrier

Lynch pin, rectangular retainer

Spool of wire (not included with the kit)

Washer

Lynch pin, semi–circular retainer

Brake strap

Brake cover

Installing the Spool Carrier

1. Remove the bolt and nut from the loader arm that secures the cylinder lock, retaining the nut.

Qty. Use

1 or 2

Installing the spool carrier

Installing the secondary spool carrier

Installing spools

Installing the spool brakes

W 2005 by The Toro Company 8111 Lyndale Avenue South Bloomington, MN 55420-1196

1. Loader arm

2. Bolt

Original Instructions (EN)

m–7699

Figure 1

3. Nut

Printed in the USA

2. Place the mounting tube bracket over the loader arm and secure it and the cylinder lock with a new bolt (4 inch) and the nut removed in step 1 (Fig. 2).

Installing Spools

1. Place a washer over the end of the spool carrier or secondary spool carrier (Fig. 2).

2. Slide the spool onto the carrier (Fig. 2).

3. Secure the spool with a washer and a lynch pin with a

semi-circular retainer (Fig. 2).

m–7700

Figure 2

1. Bolt, 4 inch

2. Mounting tube

3. Jam nut

4. Bolt, 2-1/2 inch

5. Spool carrier

6. Lynch pin with rectangular retainer

7. Secondary spool carrier

8. Washer

9. Spool (not supplied)

10. Lynch pin with semi-circular retainer

3. Thread the jam nut onto the remaining bolt (2-1/2 inch) (Fig. 2).

Installing a Spool Brake (Optional)

If you have problems with the spools freewheeling and unwinding on the carrier, install the spool brakes.

1. Slide a brake cover over a brake strap (Fig. 3).

4. Thread the bolt into the hole in the top on the mounting tube bracket, tightening it securely against the loader arm (Fig. 2).

5. Tighten the jam nut against the mounting tube bracket.

6. Place the spool carrier into the mounting tube, orienting

the horizontal tube on the carrier parallel with the crossbar on the traction unit (Fig. 2).

7. Secure the spool carrier to the mounting tube with a lynch pin with a rectangular retainer (Fig. 2).

Installing the Secondary Spool Carrier

1. Slide the secondary spool carrier into the side hole in the top of the spool carrier (Fig. 2).

2. Secure the secondary spool carrier with a lynch pin with a rectangular retainer (Fig. 2)

Figure 3

1. Brake strap with brake cover installed

2. Bracket on the spool carrier

2. Remove the lynch pin securing the spool to be braked.

3. Install a hook on the brake strap through one of the

holes from where you removed the lynch pin (Fig. 3), orienting the brake cover as follows:

• If your spool is made out of plastic, place the cloth side of the cover against the spool.

• If your spool is made out of wood, place the plastic side of the cover against the spool.

4. Hook the free hook of the brake strap to the bracket on the spool carrier (Fig. 3).

m-5342