Toro 104-0640 Installation Instructions

Chuted Blade
Part No. 104-0640
Form No. 3353-866 Rev A
Installation Instructions
Installing the Blade
1. Raise the plow about 3 feet (1 m) off of the ground.
2. Stop the engine and remove the key.
3. Remove the two click pins from the clevis pins in the
blade bracket, then remove the clevis pins (Fig. 1).
4. Slide the blade into the blade bracket and secure it at the desired depth (a change in mounting holes will change the depth by 3 in. (7.6 cm)), using the clevis pins and click pins removed previously (Fig. 1).
1
3
1. Click pin
2. Clevis pin
Figure 1
3. Blade
2
m–4910
Installing Cable
1. Remove the large wingnut and bolt from the top of the blade (Fig. 2).
2. Pull the cable guide out of the blade (Fig. 2).
3. Place the cable to be installed in the chute (Fig. 2).
4. Install the cable guide and secure it with the wingnut
and bolt (Fig. 2).
1
2
m–4908
1. Bolt
2. Large wingnut
3. Blade
3
4
Figure 2
4. Cable guide
5. Chute
5
W 2005 by The Toro Company 8111 Lyndale Avenue South Bloomington, MN 55420-1196
Original Instructions (EN)
Contact us at www.Toro.com
All Rights Reserved
Printed in the USA
5. Secure the end of the cable coming out of the bottom of the blade to a post or have someone hold it.
6. Begin plowing while routing the cable over the plow and into the blade (Fig. 3).
m–4909
Figure 3
7. When finished, remove the plow from the soil and remove the cable from the blade.
Cleaning the Blade
After each use, clean the blade as follows:
1. Remove the large wingnut and bolt from the top of the blade (Fig. 2).
2. Pull the cable guide out of the blade (Fig. 2).
3. Wash out the inside of the chute with water to remove
any dirt.
4. Wash the rest of the blade.
5. Install the cable guide and secure it with the wingnut
and bolt (Fig. 2).
2
Loading...