Toro 100-6097 Installation Instructions

SEAT KIT

FORM NO. 3323-325

PART NO. 100-6097

Loose Parts

Note: Use the chart below to identify parts for assembly.

DESCRIPTION QTY. USE

Seat (includes switch) Adapter wire

Installation instructions 1 Read before installing

This seat is designed to replace seats on older model tractors utilizing a different version of a seat interlock switch. Some modification, using the adapter wire, is necessary to update to this assembly.

Install seat

4. Install the wire harness adapter by sliding the

wire connectors onto the stripped ends and crimping with a pair of wire crimpers (Fig. 1).

INSTALLATION

INSTRUCTIONS

Assembling Seat to Tractor

Remove Old Seat

1. Disconnect the seat switch wire at the connector

under the seat. Remove the seat. If seat adjusters were installed, remove them and install on the new seat.

2. Remove the connector from the tractor wiring

harness by cutting the wires at the connector (Fig.1 ).

3. Strip the insulation back on each wire

approximately 1/4” (Fig.1 ).

The Toro Company – 1999

Printed in USA

Installation Instructions

m–4520

Figure 1

1. Seat switch lead

2. Adapter wire

3. Tractor wire harness (end connector removed)

4. Stripped ends

5. Crimp connectors

Install New Seat

1. Install the new seat using the hardware from the

old seat.

2. Connect the seat switch to the adapter, added to

the tractor wire harness.

3. Check the seat for proper function as described

in the tractor Operators Manual.