Toro 100-5841 Installation Instructions
FORM NO. 3323-612
Bagging Baffle Kit
for 48 OFZ Deck
Part No. 100–5841
Loose Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Right-hand Baffle
Left-hand Baffle
Screw
Flat Washer
Retainer Nut
Lock Nut
Pre-Installation
1
1
6
Install Baffles
4
2
4
1. Disengage the power take off (PTO), set the
parking brake, and turn the ignition key to
“OFF” to stop the engine. Remove the key.
Installation
Instructions
POTENTIAL HAZARD
• Blade is sharp.
WHAT CAN HAPPEN
• Contact with sharp blade can cause serious
personal injury.
HOW TO AVOID THE HAZARD
• Wear gloves or wrap sharp edges of the
blade with a rag.
The Toro Company – 1999
Printed in USA
2. Tilt up deck and lock into vertical position.
Refer to Tilting the Mower on page 4.
3. Thoroughly clean mower deck. All debris must
be removed to ensure baffle will fit properly
against mower deck.
4. Repair all bent or damaged areas of mower deck
and replace any missing parts.
5. For decks with serial numbers below 895000,
the locating tabs on the top side of the baffles
must be ground off (Fig. 1).
All Rights Reserved
Installation Instructions
Installing Baffles
1
m–4648
Figure 1
Right Baffle Shown
1. Locating t a b
Removing Existing Baffles
1. If in recycling mode, remove hardware for
existing baffles and then remove baffles.
Installing Retainer Nuts
1. Install one retaining leg into the square opening
of the right baffle (Fig. 2).
2. Push a screw driver into the other leg and insert
the retaining nut into the square hole (Fig. 2).
Note: Ensure retainer nut is installed as
shown in Figure 2.
3. Repeat steps 1 and 2 with the left baffle.
1. Remove the discharge brackets from the cutting
chamber (Fig. 3).
1
1
m–4635
Figure 3
1. Discharge bracket
2. Slide the baffles into place by placing the upper
tab with the retainer nut on the outside of the
discharge opening and the lower tab on the
inside of the discharge opening (Fig. 4).
1
1. Retainer N u t
2
1
Figure 2
2
1. Upper tab with retainer nut
2. Lower tab
1
3
m–4642
Figure 4
3. Discharge opening
Loading...