Toro 100-3536 Installation Instructions

FORM NO. 3323–123
CLUTCH/SEAT SWITCH KIT
Loose
Parts
NO. 100–3536
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Wire harness Interlock switch Installation instructions
1 1 1
Assemble wire harness
Description
This wire harness addition applies to GT Classic tractor models 73428 and 73448, Serial # 8900001 and up. It is applicable to a situation where engine cut out is experienced, due to body weight shift on the seat, when the clutch/brake is applied.
2
1
INSTALLATION
INSTRUCTIONS
3
Installation
1. Shut off all power from the tractor and remove
the ignition key. Set the park brake.
2. Remove the seat and rear fender to access the
shift lever neutral switch and tractor wiring harness connections.
3. Remove the shift plate and belt cover on the
right hand side to access the interlock switch mounting hole.
4. Install the interlock switch, with the terminals
facing down, in the rectangular hole in the right hand side of the hoodstand (Fig. 1).
The T
Printed in USA
All Rights Reserved
1. Interlock
2.
Right hand side of hoodstand
switch
5. Route the switch end of the kit wiring harness
forward, above the transmission housing and under the seat support to the interlock switch (Fig.2).
oro Company – 1999
Figure 1
3.
Front of tractor
m–4479
Installation Instructions
6. Connect the terminals from the wiring harness to
the interlock switch.
7. Disconnect the terminal from the shift lever
neutral switch lead and tractor wiring harness and connect each to the mating connection on the kit wiring harness (Fig. 2).
1
2
4
3
m–4473
Figure 2
1. Interlock
2. T
switch
ractor wiring harness
3.
Shift lever neutral switch wiring lead
4.
Kit wiring harness
8. Reinstall the belt cover, shift plate, rear fender
and seat.
2
Loading...