Toro 100-3390 Installation Instructions

FORM NO. 3322-866

REAR ATTACH–A–MATIC HITCH

PART NO. 100-3390

Loose Parts

Note: Use the chart below to identify parts for assembly.

DESCRIPTION QTY. USE

Mounting bracket assembly Mounting bracket Locknut 3/8–16 Carriage bolt 3/8–16 x 3 1/2” (89 mm)

1 2

Assemble Attach–A–Matic

4 4

Assembling the Rear Attach–A–Matic Hitch

The rear Attach–A–Matic is mounted on the rear axle of the tractor.

1. Push one bolt upward through the rear hole on

each side of the Attach–A–Matic, then through a mounting bracket (Fig. 1).

INSTALLATION

INSTRUCTIONS

Printed in USA

1. Facing front of tractor

2. Facing rear of tractor

3. Mounting bracket

The Toro Company – 1999

m–4493

Figure 1

4. Carriage bolt, 3/8–16 x 3 1/2” (89 mm)

5. Locknut, 3/8”

6. Latch

Installation Instructions

2. Begin to thread a locknut onto the end of each

bolt (Fig. 1).

3. Place the Attach–A–Matic under the rear axle

(Fig. 2), and rotate the mounting brackets over the top of the axle to hold the Attach–A–Matic in place.

4. Push the remaining two bolts upward through

the front holes on the Attach–A–Matic, then through the remaining holes on the mounting brackets. Thread a locknut onto each of these bolts.

1. Attach–A–Matic

2. Axle housing

Figure 2

3. Locknuts

4. Release button

m–3434

5. Tighten the nuts evenly on the bolts to hold the

Attach–A–Matic in place.

6. When mounting an attachment to the rear

Attach–A–Matic, press on the release button (Fig. 2) and open the latches. Connect the attachment into the Attach–A–Matic, then close the latches (Fig.3 ). Make sure the release button snaps back out and locks the latch in place, after closing it.

m–4495

Figure 3

5. Rear of tractor 6. Latch