Toro 100-3367 Installation Instructions

Blade Stabilizer Kit

FORM NO. 3322–786

PART

NO. 100–3367

Loose

Note: Use the chart below to identify parts used for assembly.

DESCRIPTION QTY. USE

Stabilizer
Guide
Screw
Nut, 3/8”
Screw
Nut, 5/16”

Installation Instructions

Description

This kit is designed for use with a 48” snow/dozer
blade, Model No. 79355( S/N 8900001 & up),
Model No. 716506006 (S/N T8BM0001 & up) or
95–4090 kit to stabilize the blade in a lateral
direction.

Parts

, 3/8–16 x 1” (25 mm)

, 5/16–18 x 1 1/4” (32 mm)

1
1
2
2
1
1

1

Installation of kit

Read before installing

Installation

1. If the blade is installed on a tractor, park the unit

on a level surface, lower the attachment lift. Set
the parking brake and turn the ignition key to
“Stop” to stop the engine. Remove the ignition
key.

INSTALLATION

INSTRUCTIONS

2. Remove the blade attachment from the tractor.

Refer to “Removing the Blade” in the Operator’s
Manual.

3. On the left hand frame rail position the guide

flush with the inside edge of the rail and 2 1/2”
(64 mm) from the back edge of the pivot plate
(Fig. 1).

4. Clamp the guide to the frame member. Using

the guide as a template, drill two 3/8” diameter
holes.

5

3

1

6

2

9

10

7

8. Raise and lower the blade to check the operation.

8

4

m–4406

Figure 1

1. Stabilizer

2. Stabilizer

3. Frame

4. Screw

5. Screw

, 5/16 x 1 1/4” (32

mm)

, 3/8 x 1” (25 mm)

arm

6. Guide

7.

Nut, 3/8”

8.

Nut, 5/16”

9.

2 1/2” (64 mm) distance

10.

Flush edges

5. Insert the 3/8 x 1” (25 mm) bolts through the

guide and frame and secure with 3/8” nuts
(Fig. 1). Tighten them securely.

6. Install the stabilizer arm through the guide.

Insert the 5/16 x 1 1/4” (32 mm) bolt through the
hole in the stabilizer arm and secure it with a
5/16” nut. Make sure that the stabilizer arm can
slide up and down in the hole freely.

7. Reinstall the blade attachment to the tractor.

Refer to “Installing the Blade to the Tractor” in
the Operator’s Manual. Open the latches on the
front hitch and install the stabilizer. Lock the
stabilizer in place with the latches.

2