Toro 100-3295 Installation Instructions

FORM NO. 3323-175

44 Blowout Baffle Kit

Part No. 100–3295

Loose

Note: Use the chart below to identify parts for assembly.

DESCRIPTION QTY. USE

Left Baf Right Baf T

apping Screw

Pre–Installation

Parts

fle

1 1 9

Install Blowout Baf

1. Disengage the power take off (PTO), set the

parking brake, and turn the ignition key to “OFF” to stop the engine. Remove the key.

2. Remove belt covers from mower deck.

fles

INSTALLATION

INSTRUCTIONS

POTENTIAL HAZARD

• Blade is sharp.

WHAT CAN HAPPEN

• Contact with sharp blade can cause serious

personal injury.

HOW TO AV

OID THE HAZARD

• Wear gloves or wrap sharp edges of the

blade with a rag.

3. Remove mower unit (see Operator’s Manual for

instructions).

4. Tip mower deck upside down and block up ends

to ease installation of baffle components.

5. Thoroughly clean mower deck. All debris must

be removed to ensure baffle will fit properly against mower deck.

6. Repair all bent or damaged areas of mower deck

and replace any missing parts.

Printed in USA



The T

oro Company – 1999

Installation Instructions

Installing

Blowout Baffles

Note: All holes for installing Blowout baffles

need to be drilled (Fig. 1).

1. Place baffles as shown in figure 1. Note: The baffle edges need to be centered

between front roller brackets. The baffle corners must be flush to edge of deck (Fig. 1).

2. Position lefthand baffle with the outer corner flush to edge of deck and centered in the middle (Fig. 1).

3. Position righthand baffle with the straight edge parallel to edge of deck and centered in the middle (Fig. 1).

4. Using the baffles as a template mark locations of holes. Drill (9) 7/32” holes at the marked locations in the mower.

1. Baffles

Centered between

brackets Righthand Baf Straight Edge parallel to

deck edge Lefthand Baf Corners flush to deck

edge

fle

Figure 1

Nine Holes to Drill

7. T

apping Screw

Front Roller Brackets

Corner flush to deck edge

10.

Side discharge

11.

Front edge of deck



5. Install tapping screws and tighten securely (Fig. 1).

6. Rotate blades to ensure the blades do not hit the blowout baffles.

7. If the blades touch the blowout baffles repeat the steps in this section.

8. Turn deck over, reinstall deck and deck covers.

POTENTIAL

HAZARD

• A blade that is bent or damaged could

break apart and pieces could be thrown at bystanders or at you as you use the mower.

WHAT CAN HAPPEN

• Pieces of blade that may be thrown could

seriously injure or kill you or bystanders.

HOW TO AV

•

Always r

OID THE HAZARD

eplace bent or damaged blade with

a new blade.

• Never file or create sharp notches in the

edges or surfaces of blade.