Toro 100-3255 Operator's Manual
FORM NO. 3322-791
62 Gage Wheel Kit
Part No. 100–3255
Loose
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Right Bracket
Right Rear Gusset
Left Rear Gusset
Gage Wheels
Stud
Spring Disk
Nut
Washer
Parts
1
1
1
3
3
3
3
3
Install Right Front Bracket
Install Right Rear Bracket
Install Left Rear Bracket
Install Gage Wheels
INSTALLATION
INSTRUCTIONS
Flange Nut
Installing
1. Remove mower from unit. Refer to your
operator manual for instructions.
2. Put a straight edge along the right side of the
unit. Measure over 3–1/16 in. from the straight
edge to locate the position for bracket (Fig. 1).
3. Measure 3–3/8 in. down from the top of the deck
to the center of the top hole in bracket (Fig. 2).
4. Hold bracket and mark mounting location.
Printed in USA
Right Front Bracket
The T
All Rights Reserved
oro Company – 1999
3
5. Remove paint from areas that will be welded
(Fig. 1 and 2).
6. Weld bracket to the mower deck. Weld at a 3
angle (Fig. 1 and 2).
Note: When brackets are placed against deck
they will be at approximately a 3
degree angle. When deck is mounted to
unit it will become aligned with unit.
7. Repaint the area that was welded.
Installation Instructions
1. Rightside
2.
Right Front Bracket
3.
3–1/16 in. (Straight edge
to deck)
of Deck
2
Figure 1
4
3
Installing
Right Rear Gusset
1. Using the straight edge along the right side of
the unit, measure over 2–13/32 in. from the
5
straight edge to locate the position for bracket
(Fig. 3).
2. Measure 1–5/16 in. down from the top of the
deck to the center of the top hole in gusset
1
(Fig. 4).
3. Hold wheel bracket and mark mounting location
(Fig. 4).
4. Remove paint from areas that will be welded
(Fig. 3 and 4).
5. Weld bracket to the mower deck. Weld at a 3
angle (Fig. 3 and 4).
6. Repaint the area that was welded.
4. 3
Angle
5.
Straight Edge
1
1. Rightside
2.
Right Front Bracket
3.
3–3/8 in. (T
center of top hole in
bracket)
of Deck
2
op of deck to
Figure
2
4. W
eld Here
5
3
1
3
3
2 4
X
Figure 3
1. Rightside
2.
Right Rear Gusset
3.
2–13/32 in. (Straight edge
to deck)
of Deck
4. 3
Angle
5.
Straight Edge
2
Loading...