Toro 100-2517 Installation Instructions

FORM NO. 3322–680

GTS 200 UPDATE KIT

Loose Parts

Note: Use the chart below to identify parts

used for assembly.

DESCRIPTION QTY.

Engine Guard 1 Bolt 4

Before Installing

POTENTIAL HAZARD

• If you leave the wire on the spark plug,

someone could accidentally start the engine.

PART NO. 100-2517

Installation

1. Remove the four bolts securing the primer guard

and wear plates to the mower housing (Fig. 1). Discard the four bolts.

1. Primer guard

2. Bolt (4)

INSTALLATION

INSTRUCTIONS

Figure 1

3. Wear plate

WHAT CAN HAPPEN

• Accidental starting of engine could

seriously injure you or other bystanders.

HOW TO AVOID THE HAZARD

• Pull wire off spark plug before you install

kit. Also push wire aside so it does not accidentally contact spark plug.

1. Disconnect spark plug wire from spark plug.

2. Secure the engine guard, primer guard and wear

plates as shown in Figure 2 with the four new bolts supplied in this kit.

Figure 2

1. Engine guard

Printed in USA

The Toro Company – 1999