Toro 07294R, 7294 Installation Instructions

Form No. 3326-472 Rev A

Solid Windshield Kit

Workman 1 100/2100 and Twister Utility Vehicle

Model No. 07294
Model No. 07294R

Installation Instructions

Note: To attach the Solid Windshield Kit, you must have a
Canopy Kit (Model No. 07297 or 07297R) installed on
your vehicle.

Assembly

1. Position the machine on a level surface. Set the

parking brake, turn the ignition off, and remove the
key.

Caution

If you leave the key in the ignition switch,
someone could accidently start the engine and
seriously injure you or other bystanders.

Remove the key from the ignition switch before
you do any maintenance.

2. Attach the windshield tube to the front support tubes

on the canopy using 2 screws, flat washers, and capped
nuts (Fig. 1).

1

3. Remove the protective film from the windshield.

4. Install the snap-on clips to windshield as shown in

Figure 1.

5. Attach the snap-on clips on the side of the windshield

to the canopy frame. Align the clips on the bottom of
the windshield with the windshield tube and press the
windshield securely into place (Fig. 1).

6. Ensure that all of the clips are secured firmly to the

frame.

Maintenance

Danger

Remove the solid windshield before transporting
the vehicle on a trailer.

Important To prevent degrading of the windshield or

clips, clean the windshield with mild soap and water only.
Do not use glass cleaners and solvents such as ammonia,
alcohol, and petroleum distillates.

Figure 1

1. Windshield tube

2. Screw and flat washer

 2001 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196

3. Capped nut

4. Snap-on clip

234

All Rights Reserved

1

Printed in the USA