Toro 07293R, 7293 Installation Instructions

Folding Windshield Kit

Workman 1100/2100 and Twister Utility Vehicle

Model No. 07293 Model No. 07293R

Note: To attach the Folding Windshield Kit, you must have a Canopy Kit (Model No. 07297 or 07297R) installed on your vehicle.

Assembly

1. Position the machine on a level surface. Set the parking

brake, turn the ignition off, and remove the key.

Caution

If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure you or other bystanders.

Remove the key from the ignition switch before you do any maintenance.

Form No. 3326-470 Rev A

Installation Instructions

2. Attach the windshield tube to the front support tubes on

the canopy using 2 screws, flat washers, and capped nuts (Fig. 1).

3. Remove the protective film from the windshield.

4. Install the snap-on clips and receiver clips as shown in

Figure 1.

5. Hold the rubber clips (Fig. 1) and attach the top of the

windshield to the canopy frame.

6. Attach the snap-on clips on the side of the windshield to

the canopy frame. Align the clips on the bottom of the windshield with the windshield tube and press the windshield securely into place (Fig. 1).

7. Ensure that all of the clips are secured firmly to the

frame.

1. Windshield tube

2. Screw and flat washer

3. Capped nut

Figure 1

4. Snap-on clip

5. Receiver clip

6. Rubber clip

Maintenance

Danger

Remove the folding windshield before transporting the vehicle on a trailer.

Important To prevent degrading of the windshield,

clips, and hinge, clean the windshield with mild soap and water only. Do not use glass cleaners and solvents such as ammonia, alcohol, and petroleum distillates.

 2001 by The Toro Company 8111 Lyndale Avenue South Bloomington, MN 55420-1196

Printed in the USA