TOPWAY EM ENTERPRISE ONNBTONEAR User Manual
size:144*100mm
foldable size:72*25mm
BLUETOOTH ON-EAR HEADPHONES
Model: 17LY81
Charge
Bluetooth Connect
02h
solid Red solid Blue
Front
Back
PRODUCT GUIDE
Bluetooth On-ear Headphone
Power OFF
2s
Red ash 2 times
Power ON
OFF
Calling
Onn HPhone A017
Product Instructions
USB Sync & Charging Cable
Aux-in Cable
3s
solid Blue
OFF
Bluetooth
ON
Bluetooth
3s
Blue LED
will ash
Red and Blue
LED will ash
Onn HPhone A017
Play
+
Troubleshooting
I cannot turn the earphone on
Make sure that you fully charge the earphone before turning it on.
My mobile phone is not able to nd the Bluetooth earphone
Check that the earphone is in pairing mode (Blue/Red indicator light ashes quickly).
Delete the existing Bluetooth earphone name in phone, and search again.
If still no search result, please restart the headset and phone, and try again.
After successfully pairing my mobile phone and Bluetooth earphone, It got disconnected
Check if the battery level is too low.
Check whether the headset is within 10 meters (30 feet) of your phone.
The connection may be aected by obstructions such as walls or other electronic devices. Try moving
closer to the device you are connected to.
When I am answering a call, I cannot hear anything
Check whether the phone is connected with Bluetooth earphone, instead of speaker or phone
when answering a call.
Try adjusting the volume on your mobile phone.
Press the Vol+ or Vol- Buttons to adjust the volume.
When I am listening to the music, I cannot hear anything
Press the Vol+ Button to adjust the volume.
Reconnect the headset with your mobile phone.
Check if the media is playing on the phone.
I cannot charge the headset
Check whether the charging pin and the other end are connected well.
Check whether the charging cable is functional.
Note
This equipment has been tested and found to comply with the limits for a Class B digital device,
ON
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment. This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Loading...