![](/html/37/378c/378c4486a42bdba9a9c8db294974cacf2a5a0e0baec904f33c116800fbb4347d/bg1.png)
Bluetooth Headphone
In the Box
MZX250 Headphones
17LY87
QUICK START GUIDE
A Closer Look
+
-
Charging Port
Indicator Light
AUX IN Port
Micro USB Charging Cable
AUX Cable
Charging
1-2 Hours
Full Charge
(red) = Charging
(green) = Charging
Complete
Bluetooth Pairing
5-6 SEC
PRESS & HOLD
Altec kids MZX250
Wired Use
Pairing Mode
Red & Blue Flashing LED
Paired
Blue
Slowly Flashing LED
Listening to
Music
PRESS & HOLD (2 sec)
+
PRESS & HOLD (2 sec)
-
Plugging in the included
3.5mm AUX cable will
disable Bluetooth allowing
you to listen to music over a
wired connection.
![](/html/37/378c/378c4486a42bdba9a9c8db294974cacf2a5a0e0baec904f33c116800fbb4347d/bg2.png)
FCC ID:2AKI8-MZX250
FCC WARNING:
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter