TOPWAY EM ENTERPRISE BWBTRECEIVER User Manual

272mm

1. Plug 3.5mm wired headphones into Line In port (see locations of controls below).

2. Press and hold ON/OFF button for around 4 sec ,more details refer to bluetooth pairing in function list

3. The headsets are now in pairing mode and ready to be connected to your Bluetooth device.

4. Keep the Bluetooth Audio Receiver Adapter and Bluetooth enabled device within 3 feet of each
other during the pairing process.

5. Set your Bluetooth enabled device to search for Bluetooth Audio Receiver Adapter.

6. When your Bluetooth enabled device finds the Bluetooth Audio Receiver Adapter, select
“BWA18WI111” from the list of found devices.

7. After a successful registration, the LED
indicator light will slowly blink blue.

0.45M USB Charging Cable

BWA18WI111

Aux Cable

Aux out

Note

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

The device has been evaluated to meet general RF exposure requirement. The device can be used
in portable exposure condition without restriction.

there is three tone prompt, Blue light solid.

there is three tone prompt.

Press and hold for around 4 sec，LED will flash
red and blue when ready to connect，In your
device‘s Bluetooth settings activate bluetooth and
select ”BWA18WI111”，Blue LED flashes when
connected

Maximum Volume

Line in

Model: 17LY43

there are "battery low "voice prompt, Red light flash per 5s ,
30 minutes prior to battery being drained .

Red light off
Long/short press VOL+, VOL- button to adjust

there is one tone prompt, Blue light flash per 5s .
Within effective communication range, when the Bluetooth receiver

POWER ON , it will reconnected automatically.

Once into the 3.5mm Earphone, it can playback music from external device.

45mm