TOPWAY EM ENTERPRISE BTSPK Users manual

60X80MM

19YX01

Powering on

2S

enter pairing mode automatically after power
on “Pairing”
TBD : battery low

power off

press and hold the MFB button for 1s

1S

connect

17LY86

beyond operating range “disconnected”

can reconnect automatically if they connected
before or when beyond the operating range not
longer than 1 min and back to operating range
again

incoming call

incoming call（twice）+number notice one
time+incoming call

plug the USB cable to
charge, the speaker
won't be power off

plug the 3.5mm audio
cable into to play music

1

24 3

1

answer call (click)

cancel dial (click)1 play/pause (click)

1

inject call (press and hold)

1

redial the last number ( double click)

3

volume+ (press and hold)

3

next song (click)

4

volume- (press and hold)

4

previous song (click)

1

hang up call (click)

1

FCC Requirement

changes or modifications not expressly approved by the party responsible for compliance could void

the user ’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses, and can

radiate radio frequency energy, and if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

– Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with a minimum distance of 20cm

between the radiator & your body. This transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter.