TOPWAY EM ENTERPRISE BTINEAR User Manual

MOVE WIRELESS EARBUDS WITH MIC

BT EARBUD 18LY48

Phone Controls

Model: 18LY48

PRODUCT GUIDE

Press and hold

2 sec

3 Earbud Sizes

2 Hours

Full Charge

Ver.01 12/11/ 18 Ver.01 12/11/ 18 Ver.01 12/11/ 18 Ver.01 12/11/ 18

Product Information

1) Product Name: Wireless earbuds with mic;

(Solid blue)(

Charging Complete

2) Pairing Name: BT EARBUD 18LY48

3) Speaker Rated Power Input: 3mW(0.31V);

4) Speakdr Maximum Input Power: 5mW(0.40V);

5) Loudspeaker Diameter:Φ10mm;

Hang up

Bluetooth In-Ear Headphone

Ver.01 12/11/ 18

Solid red Charging

)

6) Speaker Impedance: 16±15% Ω;

7) Sensitivety: 93±3dB;

8) Charging Cable: 0.3m

Ver.01 12/11/ 18 Ver.01 12/11/ 18 Ver.01 12/11/ 18

Press and hold

5 sec

when power oﬀ

LED will ﬂash red

and blue when ready

to pair

Activate the Bluetooth and select

‘BT EARBUD 18LY48’

in the Settings of your device

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modiﬁcations to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Ver.01 12/11/ 18

Press & Hold 1S

Siri/Google Assistant

Headphones fail to turn on

BT EARBUD 18LY48

After successfully pairing, headphones disconnect

Headphones fail to charge

Ver.01 12/11/ 18