Top Signal 55 Quick Start Manual
Quick Start Guide
The Power To Stay Connected
Contact:
www.TopSignalProducts.com
Toll Free: 855-357-5500
Desktop
55 BOOSTER
Top Signal 55dB Dual Band Mobile Amplifier
top signal top signal top signal
top signal
top signal top signal
The Top Signal 55 Portable Booster
is a powerhouse wireless mobile system designed for
individuals that require the best possible cell phone
and data signal in mobile environments.
This dual band kit works with all CDMA and GSM
carriers using the 800 MHz cellular and
1900 MHz PCS frequencies.
Copyright ©2012 Top Signal
The Power To Stay Connected
The Power To Stay Connected
www.TopSignalProducts.com Toll Free: 855-357-5500
Quick Start
1
3
2
4
• Mount the suction cup window mount in a
window that faces the direction of your nearest cell phone tower.
• Make sure that the “Radial” is pointing up.
(The “Radial” is the metal post attached to the
window mount - see left image)
• You can place either the 12” Magnet Mount
Antenna or the Low-Profile Antenna on the
mount.
• Place the antenna high in the window and at
least 6” away from metal frames.
•
Note:
There must be some signal available for
the amplifier to work.
• Attach the “Right Angle Desktop Antenna” to
the “Inside Antenna” port on the amplifier.
• You may also use the “Flat Panel” mobile
antenna instead of the “Right Angle Antenna”.
Make sure that the “Flat Panel” antenna is
placed in a vertical position to work properly.
• Run the 10’ Coaxial Cable from the “Outside
Antenna” port on the amplifier to antenna
mounted on the window.
• Extend the cable the full 10 feet to you work
space.
•
Note:
Make sure not to leave any coils in
the coax cable which could cause signal
interference.
• Plug in the Top Signal amplifier using the
“Wall Plug Power Supply”.
• Switch the amplifier to “On” (Located next to
the “Inside Antenna” port).
• It is important to keep at least 10 to 15 feet
of separation between the inside antenna
and the outside window mount antenna for
optimum performance.
•
Important: Signal boosters can only amplify
existing signal. Please verify that you have
some signal before setup.
Step 1: Window Antenna Mount Step 3: Attach Inside Antenna
Step 2: Connect Coax Cable
Step 4: Begin Using Your Booster
Loading...