Top shelf Orthopedics ProtectOR Instructions For Use Manual

P/N: 025652

topshelforthopedics.com

Phone: [phone] Fax: [phone]

Tracy, CA 95304

1851 East Paradise Road, Suite A

Please read these instructions completely and carefully

before applying this product. Correct application is important

The ProtectOR

Instructions for Use

for proper function of this product.

The ProtectOR

Instructions for Use

Please read these instructions completely and carefully before applying

this product. Correct application is important for proper function of this product.

Indications: Post-transtibial amputeee.

1.

4.

6.

b.

2.

4a.

7.

c.

3.

5.

a.

d.

Applications Instructions:

1. Remove straps and foam pads from the interior of the brace before

tting the product to the patients residual limb (Image 1).

2. Position the brace alongside the residual limb to determine approx­ imate length and the amount of foam padding needed to back “ll”
the brace before applying (Image 2).

3. Insert up to 3 (1”) foam disks to accommodate the ll and to provide
additional protection to the distal portion of the limb (Image 2).

4. Open the clamshell designed brace and slide it over the surgical dressing
and residual stump (Image 3). If the dressing is smaller or larger than the
distal portion of the brace remove and adjust the “Chicago” style screw at
the end and adjust the width accordingly by selecting holes closer or
farther away from the lower portion (Image 4/4a). The brace should be
positioned so that the kneecap is protected by the are portion at the top
of the front panel.

5. Feed the 2 lower white straps through the D-Rings and secure them
to the body of the brace (Image 5).

6. Using the crescent shaped pads- position them on the medial or
lateral aspect of the knee at the supracondylar portion of the knee
joint. These aid in the anti-migration and secure t of the brace
without the use of the waist suspension strap. The crescent pads are
stackable for additional support and compression (Image 6).

7. Secure the 2 upper straps to the neoprene material on the thigh portion
of the brace, taking care to maintain the position of the antimig­ ration pads in the appropriate location once tightened. Straps can
be cut to length and re-secured using the y-tab adapters (Image 7).

e.

Use and Care: Hand wash in cold water using mild soap. Rinse

thoroughly, and air dry. If not rinsed thoroughly, soap residue may
cause skin irritation and material breakdown.
Warning: This product is to be used under the supervision of a medical
professional. This device is not intended for unsupervised public use.
If you experience any pain, swelling, sensation changes, or any unusual
reactions while using this product, consult your medical professional
immediately.
Warranty: Top Shelf Orthopedics guarantees this product to be free
of defects in material and construction, for a period of six months from
the date of purchase on the associated soft goods and straps.
Caution: Federal Law (U.S.A.) restricts this device to sale by or on the
order of a licensed health care professional. For single patient use only.

Waist Belt Use (Optional)
A. Remove the y-tab adapter from the end of the 2” waist belt material.

(Image A).
B. Wrap the 2” waist-belt around your mid section, overlapping it approx­ imately 12” (Image B).
C. Cut the excess material- feed it through the plastic buckle and apply
the y-tab adapter to the material and secure the waist belt (Image C).
D. Feed the 1 inch black strap through the “D” ring on the white “yoke
strap” axed to the body of the brace. Cutting the length and axing
the “Y” tab may be required (Image D).
E. Adjust the end of the black strap for length and apply the end
back on itself to aid in the suspension of the brace while ambulating.
A properly applied ProtectOR (Image E).

Note:

Take care to apply all straps so that the “hook” material does not rub
against your skin when secured.