TOPSCCC EX94241 Installation Manual
PCI Multi-port Serial Card
4
7. Put the chassis cover back on the computer.
8. Turn ON the power of your computer and peripherals.
9. Proceed with Software Driver Installation.
The Multi-port serial card is plug-and-play so the driver
installation is quite straightforward. Please “Browse” to the
correct path on the Driver CD when Windows asking for the
driver’s location.
Note:
To install the Windows NT driver, please run (double click) the
following installing program:
Run
Install_Serial.exe
in
\IO\OXFORD\winNT4
folder for
Serial Ports
Run
Install_Parallel.exe
in
\IO\OXFORD\winNT4
for
Parallel Port
Install 4S (or 8S) octopus
cable
4. Software Driver Installation
1
Congratulation on your purchasing this high performance PCI
multi-port serial I/O adapter. The adapter is high speed PCI bus
based and plug-and-play compliant. Its serial ports are fully
16C950 (and 16C550 backward) UART compatible with most of
the RS-232C devices available from the market.
Features:
Fully PCI Bus Specifications 2.2 compliant
Models: 4S (with DB37 connector), 4S (with 4-port RJ-45
connector) and 8S (with DB62 connector)
128-byte FIFO 16C950 UARTs, Backward Compatible with
16C550
Automated in-band flow control using programmable
Xon/Xoff in both directions
Supports Win98/Me, NT, Windows 2000 and XP
Figure 2-1 4S with DB37 Connector
PCI Multi-port Serial Card
Installation Guide
1. Introduction
2. Layout
J2: S1
J3: S2
J4: S3
J5: S4
J6: S1~S4
External
Connector
PCI Multi-port Serial Card
2
Figure 2-2 4S with 4-port RJ-45 Connector
RJ45 PIN# SIGNAL
1 DCD
2 TXD
3 RXD
4 DSR
5 GND
6 DTR
7 CTS
8 RTS
Figure 2-3. 4S with DB37 + Optional Parallel Port
Connectors
J2: S1
J3: S2
J4: S3
J5: S4
J6: S1~S4
External
Connector
J2: Parallel Port Connector
J1: S1~S4
External
Connector
1 8
PCI Multi-port Serial Card
3
Figure 2-4. 8S with DB62 Connector
1. Turn the system power OFF before installation!
2. Use static electricity discharge precautions.
3. Remove the chassis cover from your computer
4. Locate an unused PCI slot (typically white or ivory) and
remove the corresponding slot cover from computer
chassis.
5. Plug the PCI multi-port serial card to the unused PCI
expansion slot and attached the I/O card bracket to the
computer chassis screw.
6. Installing the serial and parallel port cables
For 4S with DB37 connector model, please connect the
DB37-to-DB9x4 cable to its J1 external connector.
For 8S with DB62 connector model, please connect the
DB37-to-DB9x4 cable to its J1 external connector.
3. Installing the Multi-port Serial Card
J1: S1~S8
External
Connector
Loading...