Top Gun Park Flite Extra 330L Instruction Manual

2

Extra 330L

INSTRUCTION MANUAL

CONGRATULATIONS ON PURCHASING THE EXTRA330L RTF

Top Gun Park Flite are proud to present this high performance sport scale model of the famous Extra 330L.
We feel that this model emulates the style, performance and character of its full size counterpart.

Supplied as a Ready to Fly package with transmitter, LiPo flight battery and charger, this model has been
designed with the utmost care and attention to detail to produce a light weight, strong, and highly aerobatic
flying model.

This model is a high performance miniature aircraft that allows intermediate to advanced model pilots to
perform both precision aerobatic manoeuvers and the latest 3D style of flying. The light weight and large
wing area allow the model to fly extremely slowly, while still maintaining full control.

It is not a trainer and should not be tackled until the pilot is proficient on low wing aerobatic models.

These instructions assume a reasonable level of competence for both building and flying and we
recommend that the model is flown at a recognised club with frequency control measures and suitable third
party insurance.

The owner – pilot of this model should take note of regulations, and local bylaws before flying this aircraft.

Please take time to read through these instructions before commencing assembly. We list operations in
order of works to reduce the risk of damage during assembly.

RTF MODEL

3

WARNING

This R/C aircraft is not a toy and can result in serious
bodily harm, injury and property damage if misused. Fly
only in open areas and at preferably BMFA recognised
clubs and sites.

SPECIFICATIONS

WING SPAN: 960 MM
LENGTH: 897 MM
WING AREA: 19.3 DM
WEIGHT: 620 G
RADIO: 4 FUNCTION 35MHZ PPM

3 QTY 9G SERVOS
25AMP BRUSHLESS ESC

MOTOR: 400 SIZE IN RUNNER

8:1 REDUCTION GEARBOX
13 X 6.5 PROPELLOR

11.1V 1500MAH LIPO BATTERY
STATIC THRUST 1050G

PLEASE READ THROUGH
THE WARNINGS BEFORE
USE.

An 11.1V 1500 mAh lithium
polymer (LiPo) battery rated at 10C
and mains charger is included as
part of this package and these
cells must be operated with care to
prevent the risk of fire.

LiPo Batteries are soft cased and
can be easily damaged by sharp
items, puncturing of the soft casing
can cause fires and we recommend
that they are stored and handled
carefully.

Use only a LiPo rated charger, set
to a maximum of 3 cells (11.1v)
and 1 amp charge current.

Remove battery from the aircraft
and charge on a non flammable,
non conductive surface

Due to continual and ongoing
product development the parts
shown in the manual may differ
from those supplied.

4

TRANSMITTER

The Suplex 4 is a fully proportional 4 function
35Mhz transmitter

It incorporates the following features

ü Dual rates
ü Elevon mix for channels 1 and 2
ü Servo reversing
ü Two stage visible and audible Low power
warning

Transmitter requires 8 off AA size dry cells or high
capacity NiMh batteries to be inserted before
operation.

Wing assembly, supplied
complete and ready to fit with
servo, push rods clevis
connectors and control horns
installed.

Fuselage assembly, supplied
complete and ready for use.
Motor with propellor and spinner
fitted. 18 Amp Electronic Speed
Control (ESC), 35mhz 4ch
receiver, rudder and elevator
servos connected to push rods
and clevis connectors and control
horns.

SECTION 1: KIT CONTENTS AND DESCRIPTION

Horizontal stabiliser and fin
assemblies. Supplied complete
and ready to fit with hinges and
control horns installed.

5

Undercarriage assembly, ready
for use, with wheels and spats.
Tail wheel is pre fitted to
fuselage

11.1V 1500mAh Lipo Battery
with matching 1A output mains
wall charger.

JST to Tamiya adaptor lead for
connection between Battery and
charger.

Hardware pack including
screwdriver, plastic wing bolts,
spare output gears, clevis
connectors and thumb screw.

Spare propellor.

13” diameter x 6.5” pitch.