Top Dawg Electronics TDEE1440CAM User Manual

1440P Dash Camera Manual
1.Product Introduction
This 1440P Dash Camera is a high resolution, WDR (Wide Dynamic Range) camera with True
H.264 Compression. This camera offers a wide 140° viewing angle and 2304 x 1440p high
resolution camera for stunning, top of the line, HD dash camera video, and can use up to a
256GB SD Card!
1.Bracket
2.Car charger port
3.Menu
4.Up
5.Down
6.OK
7.Bracket lock
8.Speaker
9.Mic
10.Camera
11.USB
12.Reset
13.Blue light
14.Red Light
15.Display
16.SD card hole
17.On/Off
1440P Initial Setup Instructions
It is recommended that you FORMART SD card.
Press bottom left “OK” button, make sure camera is not recording.
Once camera is not, press top left, menu button
On menu screen, using middle down arrow button, press 2x or until you
highlight “Menu”
Press bottom left “OK” button- press middle top left arrow button to highlight “FORMAT”. Press Ok- Press down arrow to highlight “Yes”, Press bottom left “Ok” button. SD card is now formatted. If you format SD card in the future, it
will erase everything that is currently on card.
We recommend formatting card once a month.
Setup instructions to keep dash camera from freezing:
Press bottom left “OK” button, make sure camera is not recording.
Once camera is not recording, press top left, MENU button
On menu screen, using middle down arrow button, press 2x or until you have
“Menu” highlighted, Press Ok
Press the bottom left down arrow button until “G-Sensor” is highlighted, Press Ok and set to “LOW”, Press OK
Press the bottom left down arrow button until “Park Monitor” is highlighted
Press bottom left “OK” button to make sure Parking Monitor is OFF
You are now done with initial setup.
Press top left Menu button to get back to your main video mode.
Press bottom left “OK” button to start recording
Master Reset “hole button” is located on right side of camera-Using a safety pin, thumbtack, toothpick, etc. Press inside hole for a master reset of 1440P dash camera.
Loading...
+ 5 hidden pages