TopCold GK60, BC145V, GN60, SD1381, SDN1381 Instruction Manual

Refrigerators/Freezers

Instruction manual

BC145V/GK60/GN60

SD1381/SDN1381

PLEASE READ THE OPERATION MANUAL BEFORE USING.

SAVE THIS MANUAL FOR LATER USE.

Safety Tips

• Position on a flat, stable surface.

• A service agent/qualified technician should carry out installation and any repairs if required. Do not

remove any components or service panels on this product.

• Consult Local and National Standards to comply with the following:

• Health and Safety at Work Legislation

• BS EN Codes of Practice

• Fire Precautions

• IEE Wiring Regulations

• Building Regulations

• DO NOT use jet/pressure washers to clean the appliance.

• DO NOT use the appliance outside.

• DO NOT use this appliance to store medical supplies.

• DO NOT use electrical appliances inside the appliance (e.g. heaters, ice-cream makers etc.).

• DO NOT allow oil or fat to come into contact with the plastic components or door seal. Clean

immediately if contact occurs.

• DO NOT store products on top of the appliance.

• Bottles that contain a high percentage of alcohol must be sealed and placed vertically in the

refrigerator.

• Always carry, store and handle the appliance in a vertical position and move by holding the base of

the appliance.

• Always switch off and disconnect the power supply to the unit before cleaning.

• Keep all packaging away from children. Dispose of the packaging in accordance with the regulations

of local authorities.

• If the power cord is damaged, it must be replaced by a agent or a recommended qualified technician

in order to avoid a hazard.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety

• Children should be supervised to ensure that they do not play with the appliance

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your product.

Pack Contents

The following is included:

• Refrigerator / Freezer • Keys x2

• Shelves – 2 big+1 small(200) • Spacers x 2

Shelves – 3 big+1 small(400/600) • Instruction manual
Prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully
functional and free of damage.
Should you find any damage as a result of transit, please contact your dealer immediately.

Installation

1. Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are

thoroughly removed from all surfaces.

2. Maintain a distance of 2cm (0.7 inches) between the unit and walls or other objects for ventilation.

Increase this distance if the obstacle is a heat source.

Operation

1. General

ECS-10HT1 could be specially used in kitchen cabinet and air curtain cabinet, unit Celsius and
Fahrenheit could be switched by menu, Max. two channel of sensors separately used for cabinet
temperature adjustment and defrost control; Compressor and defroster relay could select the
specification 30A-10A, or 17A-10A; The display of the controller could be selected as cabinet
temperature or evaporator temperature; split design between control board and display panel, very
convenient for repairing and replacement.

2. Technical parameters

2.1 Measuring range：-50℃～+90℃ or -58℉～194℉(only when sensor calibration is 0)

2.2 Resolution：1℃or 1℉；

2.3 Accuracy：-40℃～50℃,±1℃， 51℃～70℃ ,±2℃，others,±3℃

or -40℉～122℉,±2℉，123℉～158℉,±4℉，others,±6℉；

2.4 Cabinet temperature control range：-50℃～90℃ or -58℉～194℉；

2.5 Power supply：220VAC、50/60Hz；

2.6 Power consumption：<3W

2.7 Output capacity：

Refrigeration：30A/240VAC，normal open， directly drive a single phase 1.5HP（220VAC）load；
(or optional) 17A/240VAC，normal open， directly drive a single phase 1.0HP（220VAC）load
Defrost or lighting relay： 10A/240VAC，normal open， directly drive heater strip Max.1200W

(220VAC);
(or optional) 05A/240VAC，normal open， directly drive heater strip Max.500W (220VAC).
Note: Defrost or lighting relay could be used as lighting relay or defrost relay.
When parameter U3=0, defrost/lighting relay is used as defrost output, and it has no function of lighting

control at this time;
When parameter U3=1, defrost/lighting relay is used as lighting output, and it has no defrost function,

defrost is proceeded as off-cycle defrost.

2.8 Input terminal: cabinet sensor, evaporator sensor (optional)

2.9 Work ambient temperature：0℃～55℃ ；

2.10 Storage temperature：-25℃～75℃ ；

2.11 Relative humidity：20%～85%（non condensing）

2.12 Front panel protection level: IP65

3. Operation and display panel