Tonka Playskool User Manual

*

x3

BATTERIES INCLUDED

1.5VA A or R6 size

Replace with 3 x 1.5V “AA” or R6 size batteries.
Alkaline batteries recommended. Phillips/cross
head screwdriver (not included) needed to
replace batteries.

This product contains small
parts which are necessary for
assembly. Prior to and during
assembly of this product, keep
small parts out of children’s
reach. Small parts pose a
choking hazard to children
under 3 years.

TO AVOID SERIOUS INJURY: continuous adult supervision required;
never use near motor vehicles, near streets, swimming pools, hills,
steps, or sloped driveways. Always wear shoes. Allow only one rider.

WARNING:

™

Scoot ’n Scoop 3-in-1 Ride-on™

with Revvin’ Beepin’ Wheel™

Thank you for choosing this TONKA toy!

Push

1

(9+ months)

Walk

2

(12+ months)

OVER 9 months

to 3 years

91056

Adult supervision

required.

Includes REVVIN’ BEEPIN’

WHEEL, truck body, seat,

gravel guard, rear axle

assembly, 2 screws,

3 plastic blocks and

instructions.

Adult assembly

and Phillips/

cross head

screwdriver

(not included)

required.

Ride

3

(18+ months)

For children up to
42 pounds (19 kg).

ASSEMBLY

Basic

Attach rear axle
assembly to truck body
with the 2 screws.

Walk Mode

1. Remove seat by
pressing both
buttons at the
same time and
lifting the seat up.

Push Mode

1. Make sure seat
is locked in the
“down” position.

2. Make sure gravel
guard is locked
in the “down”
position.

2. Attach seat in the
“up” position. Push
down until the
buttons click to
lock seat in place.

Ride-on Mode

1. Remove seat by
pressing both buttons
at the same time and
lifting the seat off the
truck body.

2. Attach seat in the
“down” position. Push
down until the buttons
click to lock seat
in place.

NOTE: Seat must be in “down” position for child to ride on
vehicle. Never allow child to sit or ride on gravel guard.

3. Remove gravel guard by pushing
both buttons at the same time
and lifting the gravel guard up.

4. Attach the gravel guard
in the “up” position by
pushing both buttons
at the same time and
inserting guard vertically
into slot, then pushing
down on the gravel guard
until buttons click and
guard is locked in place.