Tonka 91056 User Manual
*
OVER 9 months
to 3 years
91056
Scoot ’n Scoop 3-in-1 Ride-on™
with Revvin’ Beepin’ Wheel™
Thank you for choosing this TONKA toy!
Includes REVVIN’ BEEPIN’
WHEEL, truck body, seat,
gravel guard, rear axle
assembly, 2 screws,
3 plastic blocks and
instructions.
Adult supervision
required.
x3
BATTERIES INCLUDED
1.5V A A or R6 size
Replace with 3 x 1.5V “AA” or R6 size batteries.
Alkaline batteries recommended. Phillips/cross
head screwdriver (not included) needed to
replace batteries.
1
Push
(9+ months)
2
Walk
(12+ months)
3
Ride
(18+ months)
This product contains small
parts which are necessary for
assembly. Prior to and during
assembly of this product, keep
small parts out of children’s
reach. Small parts pose a
choking hazard to children
under 3 years.
TO AVOID SERIOUS INJURY: continuous adult supervision required;
never use near motor vehicles, near streets, swimming pools, hills,
steps, or sloped driveways. Always wear shoes. Allow only one rider.
WARNING:
™
Adult assembly
and Phillips/
cross head
screwdriver
(not included)
required.
For children up to
42 pounds (19 kg).
ASSEMBLY
Basic
Attach rear axle
assembly to truck body
with the 2 screws.
Push Mode
1. Make sure seat
is locked in the
“down” position.
2. Make sure gravel
guard is locked
in the “down”
position.
Walk Mode
2. Attach seat in the
“up” position. Push
down until the
buttons click to
lock seat in place.
1. Remove seat by
pressing both
buttons at the
same time and
lifting the seat up.
Ride-on Mode
3. Remove gravel guard by pushing
both buttons at the same time
and lifting the gravel guard up.
1. Remove seat by
pressing both buttons
at the same time and
lifting the seat off the
truck body.
2. Attach seat in the
“down” position. Push
down until the buttons
click to lock seat
in place.
NOTE: Seat must be in “down” position for child to ride on
vehicle. Never allow child to sit or ride on gravel guard.
4. Attach the gravel guard
in the “up” position by
pushing both buttons
at the same time and
inserting guard vertically
into slot, then pushing
down on the gravel guard
until buttons click and
guard is locked in place.
Loading...