TOWER SPEAKER SYSTEM
TOWER SPEAKER SYSTEM
WITH BLUETOOTH® WIRELESS
WITH BLUETOOTH® WIRELESS
TECHNOLOGY
TECHNOLOGY
Owner's Manual
PLEASE READ BEFORE OPERATING THIS EQUIPMENT.
Model: TA-304B
Size: 148.5(W) x 210(H)mm (A5)
1
Insert the small plug from the supplied AC/DC
Adaptor to the DC IN Jack on the unit. Insert the
AC/DC adaptor to a wall outlet having AC 100-240V~,
50/60Hz .
NOTE: This AC/DC Adaptor is intended to be correctly
orientated in a vertical or floor mount position.
2. Wooden Base
TO DC IN JACK
To Wall Outlet
6
5
4
1
2
3
as the figures above.
Supplied screwdriver
1. Assembly the two wooden bases to the bottom of unit by the supplied assembly
screws and screwdriver as the figure above.
1. FM ANT (FM ANTENNA)
2. POWER ON/OFF SWITCH
3. DC IN JACK
4
1
2
4. AUX IN 2 JACKS
5. AUX IN 1 JACK
6. (BLUE TOOTH) INDICATOR
7. AUX 1 INDICATOR
8. AUX 2 INDICATOR
9. STANDBY/FM INDICATOR
10. SOURCE BUTTON
11. STANDBY ON/OFF BUTTON
12. VOL - (VOLUME DOWN) BUTTON
13. VOL + (VOLUME UP) BUTTON
14. TUNE +/ BUTTON
15. TUNE -/ BUTTON
11
10
3 5
78
6
9
15
14
12
13
5
1
2
3
5
8
1. Standby ON/OFF BUTTON
2. (MUTE) BUTTON
3. SOURCE BUTTON
4. RESET BUTTON
4
6
7
10
9
6. (PLAY/PAUSE) BUTTON
7. TUNE +/ BUTTON
8. VOL (VOLUME) +/- BUTTONS
9. TREBLE +/- BUTTONS
5. TUNE -/ BUTTON
10. BASS +/- BUTTONS
BATTERY PRECAUTIONS:
CONNECTION
Connect to External Audio Device with 3.5mm Jack:
Connect to External Video/Audio Device with RCA Jacks:
8
OPERATIONS:
1. Connected the external Audio or Video/Audio Devices to the unit as previous procedures.
2. Slide the POWER ON/OFF Switch on the rear of unit to ON position to turn the unit to Standby
mode. The Power Indicator will light.
3. Press and hold the button on the unit or press the button on the Remote Control to turn on
the unit from Standby mode.
4. Press the SOURCE button on the unit or Remote Control to select input source as desire.
A. If FM (Radio) is selected, STANDBY/FM Indicator will blink:
i. Press the TUNE +/ button repeatedly to search and plays the next available FM station.
ii. Press the TUNE -/ button repeatedly to search and plays the previous available FM station.
iii. To searching the stations from begin. Press the RESET button on the Remote Control to
reset the radio to minimum frequency.
Notes:
and extended the wire or relocation the wire to improve the radio reception.
B. If AUX 1 is selected, the AUX 1 Indicator will light. Plays the music in the AUX 1 connected
Audio device as usual.
C. If AUX 2 is selected, the AUX 2 Indicator will light. Plays the video or music in the AUX 2
connected Video/Audio device as usual.
D. If BT (Blue Tooth) is selected, the Indicator will light and blinking. If this is the first time to use
BT or re-pairing the unit to a new BT device, pairing the unit to external BT device as bellows:
i. Power on the external BT device and enter to searching mode.
ii. Start pairing as the on screen instructions on the external BT device.
iii. After paired, the Indicator will stop blinking. (For details pairing procedures, please refer
to the user’s manual of your BT device.).
Notes:
on the display of external BT device.
Normal operation after paired:
i. Turn on the BT function of the external BT device.
ii. Power on the unit and selected the input source to BT as previous procedures.
iii. Wait a few seconds until the unit paired to the external BT device automatically. (The
Indicator will stop blinking).
iv. Plays the music in the paired BT device as usual.
5. Press the VOL (Volume) +/- buttons to adjust volume level.
6. Press the button on the remote control to turn off the sound temporary, press again to turn the
sound back.
7. Press the BASS +/- buttons on the remote control to enhance or reduce the bass level (low audio
frequency) as desire.
8. Press the TREBLE +/- buttons on the remote control to enhance or reduce the treble level (high
audio frequency) as desire.
9. When finished, press and hold the button on the unit or press the button on the Remote
Control to turn off (standby) the unit.
NOTE: If long period of time will not use the unit, power off the unit by slide the POWER Switch
to OFF position or unplug the AC/DC Adaptor from the unit and wall outlet.
The Antenna wire on the rear of unit is for radio reception. If reception is weak, unwound
If a stereo FM station was searched, the unit will plays it in stereo mode automatically.
iv. Plays the music in the paired BT device as usual.
When the external BT device searched the unit, our model number “CHT 941” will appears
Pairing code “0000” may need to enter.
9
DC 12V,2A
not
of
accordance
interference
DC 3V,1 x CR 2025 button cell (Included)
FM 87.5-108 MHz
4 x 4 Ohms, 6 W
Accessories:
1 x Remote Control ( uses 1 x CR 2025 button cell,induded )
1 x AC/DC Adaptor ( Input: AC 100-240V~,50/60Hz 1A;
1 x Audio Connection Cable with 3.5mm Stereo plugs
1 x User's Manual
2 x Wooden Stand
6 x Assembly Screws
1 x Screwdriver
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
This device and its antenna(s) must not be co-located or operating in conjunction with any
other antenna or transmitter.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
A )2,V21 CD tuptuO
10
LIMITED WARRANTY
Craig warrants this product to be free from manufacturing defects in material and
workmanship under normal use for a period of 90 days from date of purchase. If service
is required, please return the product to the store where it was purchased for exchange;
or, pack the unit in the original packing material with all accessories if applicable, a copy
of your sales receipt and a Cashier’s check or Money Order for $12.00 (to cover shipping
and handling costs) payable to Craig Electronics Inc. For consumers in Canada, please
make sure that the cashier check or money order is redeemable through a U.S. bank.
Ship your product freight pre-paid. Your unit will be repaired, replaced or if the unit can
not be repaired or replaced, a refund will be forwarded to you within four weeks of receipt
of your unit. Please ship your unit to:
Craig Electronics Inc.
1160 NW 163 Drive
Miami, Fl 33169
This warranty is void if the product has been: a) Used in a commercial application or
rental. b) Damaged through misuse, negligence, or abuse. c) Modified or repaired by
anyone other than an authorized Craig service center. d) Damaged because it is
improperly connected to any other equipment.
Note: This warranty does not cover: a) Ordinary adjustments as outlined in the Owner’s
Manual which can be performed by the customer. b) Damage to equipment not properly
connected to the product. c) Any cost incurred in shipping the product for repair. d)
Damage to the product not used in the USA.
This warranty is not transferable and only applies to the original purchase. Any implied
warranties, including the warranty of merchantability, are limited in duration to the period
of this expressed warranty and no warranty whether expressed or implied shall apply to
the product thereafter.
Under no circumstance shall Craig be liable for any loss or consequential damage arising
out of the use of this product. This warranty gives specific legal rights. However, you may
have other rights which may vary from state to state. Some states do not allow limitations
on implied warranties or exclusion of consequential damage. Therefore, these
restrictions may not apply to you.
To Obtain Service on your Product
email:service@craigelectronics.com
Printed in China CHT941_WC_E0FG1_V0US
Size: 148.5(W) x 210(H)mm (A5)
Loading...