Toner Plastics 87389 User Manual

Toner Plastics ABS 3D Printer Filament Page 1 of 6 Rev. 10/06/2015

Material Safety Data Sheet

In accordance with 29 CFR 1910.1200, ANSI Z400.1-2004, and ISO 11014-1: 1994.

1. IDENTIFICATION
Product name: ABS 3D Printer Filament
Product Use: For use in 3D printing machines
Supplier: Toner Plastics Inc., 35 Industrial Drive, East Longmeadow, MA 01028
Emergency telephone numbers (24 hours a day): [phone]

2. HAZARDS IDENTIFICATION

Most Important Hazards: None
Adverse Human Health Effects: None
Environmental Effects: None
Physical and Chemical: None

3. COMPOSITION / INFORMATION ON INGREDIENTS

Substance or Preparation: Substance
Chemical Name: Acrylonitrile-Butadiene-Styrene Copolymer
Content:

 CAS No. 9003-56-9: > 98% Styrene-acrylonitrile-butadiene copolymer
 CAS No. 100-42-5: < 0.1% Styrene

Additional information: Does not contain dangerous substances above limits that
need to be mentioned in this section according to applicable legislation.

4. FIRST AID MEASURES

Inhalation: In case of gases evolving from melted filament, move subject to fresh
air. Treat symptomatically.
Skin Contact: Wash with water. In case of melted filament, wash affected skin
area and clothing with plenty of (soap and) water. Seek medical advice.
Eye Contact: In case of small particles, flush with plenty of water for at least 15
minutes. Seek medical advice if any small particles still remain. In case of gases
evolving from melted filament of high temperature, flush with plenty of water for
at least 15 minutes. Seek medical advice if necessary.

Toner Plastics ABS 3D Printer Filament Page 2 of 6 Rev. 10/06/2015

Ingestion: Induce vomiting. Rinse mouth with water. Seek medical advice if
necessary.

5. FIRE-FIGHTING MEASURES

Extinguishing Media: Water, Foam, Dry chemical powder
Special Fire-Fighting Procedure: Self-contained breathing apparatus
Fire and Explosion Hazards: None

6. ACCIDENTAL RELEASE MEASURES

Methods for Cleaning up: Recovery if not contaminated or disposal
Personal Precautions: Strands/string remaining on ground may cause slipping;
provide adequate ventilation.
Environmental Precautions: Gather small particles thoroughly to avoid birds or
fish taking from draining water.

7. HANDLING AND STORAGE

Handling: Prevent fire around handling area. Maintain good housekeeping
standards to prevent accumulation of dust.
Storage: Keep the materials in a cool dry place. Protect from direct sunlight, rain
and violent temperature fluctuation.

8. EXPOSURE CONTROLS / PERSONAL PROTECTION

Occupational exposure limit values:

CAS No.

Designation

Type

Limit value

100-42-5

Styrene

OSHA: Ceiling
USA: ACGIH: STEL
USA: ACGIH: TWA
USA: NIOSH: STEL
USA: NIOSH: TWA
USA: OSHA: TWA

200 ppm
170 mg/m3, 40 ppm
85 mg/m3, 20 ppm
425 mg/m3, 100 ppm
215 mg/m3, 50 ppm
100 ppm

Biological limit values:

CAS No.

Designation

Type

Limit value

Parameter

Sampling