Tone Freak Naked OD User Manual

Thank you for your purchase of the Naked OD™ by
Tone Freak Effects! The Naked OD™ is a lighter
OverDrive. Placed in front of an already slightly or
fully driven amp, the Naked OD™ can clean boost
your tone as well as giving you even more "hair".
With a clean amp, the Naked OD™ adds a nice
crunch for chord and solo work.

CONTROLS
Drive: Increase the gain of the unit by turning the

knob clockwise. Turning the knob counter clockwise
will decrease the gain.
Tone: Turing the knob clockwise will increase the
high-end tone. Counter clockwise will increase the
low-end tone.
Level: To increase the output volume, turn the knob

clockwise. By turning the volume control counter clockwise, you will decrease the output volume.

3-Way Mini-Toggle: The Naked OD™ has 3 different clipping sections.

• Right position uses symmetrical clipping and has the most “amp-like” characteristic of
the clipping variations. This position has the most gain and compression compared to the
other two positions.

• Left position engages the asymmetrical clipping. You will find this position to have a
higher output volume from the Right position, so adjust your Level control to compensate.
Asymmetrical clipping produces a more “classic” quality compared to the other two
positions.

• Middle position is also called the “diode lift” position. The Left and Right positions use
diodes to clip the signal, but the Middle position doesn’t have any diodes, so the resulting
tone is more “open” than the other two positions. NOTE: The Middle position has the
highest output volume, so be careful when engaging this position.

The Naked OD™ uses a 9V battery or a 2.1 mm center negative pin power adapter.

Tone Freak, LLC

4952 William Ave, Cypress CA 90630, USA

www.tonefreak.com email: [e-mail]