closer to nature perfect prep machine
IMPORTANT WARNINGS - Keep this
instruction sheet for future reference as
it includes important information.
• Do not immerse in water.
• This appliance can be used by children
aged from 8 years and above and
persons with reduced physical,
sensory or mental capabilities or lack
of experience and knowledge if they
have been given supervision or
instruction concerning use of the
appliance in a safe way and
understand the hazards involved.
Children shall not play with this
appliance. Cleaning and user
maintenance shall not be made by
children without supervision.
• Keep the appliance cord out of reach
of children.
WARNING LIGHTS ACTION BUTTONS
CHANGE
FILTER
WATER TANK
HOT
WATER LEVEL
LOW
DECALC/
DESCALE
CLEANING
MODE
INSTRUCTIONS FOR USE
CLEANING
MODE
FILTER
VOLUME
RESET
DECALC/
DESCALE
WATER
HOPPER
WATER
FILTER
START / STOP
BUTTON
SETTING
DIAL
DISPENSER
DISPENSER
OUTLET
OUTLET
WARNING
LIGHTS
ACTION
BUTTONS
WATER
TANK
FOR DOMESTIC USE ONLY - NOT INTENDED FOR COMMERCIAL USE
BOTTLE
STAND
1. SET UP AND
CLEANING
Before first use you need to run a cleaning cycle – which should take approximately 10 minutes. You should
clean your unit as part of the set up and again whenever you replace your filter. For hygiene and safety
reasons you should always clean your unit if it has been unused or in storage for longer than 2 weeks.
1
Place a container under the
dispenser outlet to capture the
water used to clean the system (at
least 1 litre capacity).
2 3 4
Plug in the unit, the tank empty
warning light will illuminate.
With the water hopper in place (but
not the filter) fill the hopper with 1
litre of freshly boiled water - HOT
WATER -
5 6 7 8
Wait for the tank empty warning
light to go out. The water tank hot
light will illuminate.
Press the cleaning mode button and
hold for 2 seconds. The cleaning
mode light will illuminate.
Wait whilst the boiled water is
emptied from the tank, through the
dispenser, into the container that you
placed under the outlet in step 1.
The tank empty warning light will
illuminate once the water has
flushed through the system.
Discard the water captured in your
container and replace it under the
dispenser.
9a 9b 10 11
*Handling the filter cartridge by the top only:
• Remove the filter cartridge from packaging
• Remove sticker from the top of filter
• Fill a bowl with potable (drinking) water
• Fully submerge the cartridge in the water
• Gently agitate until the bubbles cease
12
Remove the water hopper and
fit the filter*.
Replace in the water tank.
13 14
Fill the hopper with COLD WATER. Wait for the tank empty warning
light to go out.
15
Press the start/stop button. A red
light will flash.
The appliance will dispense an
amount of hot water.
Press the start/stop button again. A
green light will flash and an amount
of water will be dispensed to finish
the cycle.
FILTER
VOLUME
RESET
Press the filter volume reset button
for 2 seconds to clear the memory.
Discard dispensed water.
Your system is now ready to use.
Loading...