O:\Cad\JME INSTRUCTION SHEETS\1907629.dwg
MODULAR SIMPLI-FLEX
ESF SERIES DISPENSER INSTRUCTIONS
MOUNTING THE DISPENSER:
Elevator dispensers may be mounted in
any position.
1. Position wall brackets (#4) in desired location
allowing sufficient height to dispense.
Mark location of screw holes on mounting2.
surface.
Pre-drill holes for #10 x 3/4" mounting screws
3.
(#3) provided.
Screw wall brackets to mounting surface.4.
NOTE: screw anchors may be necessary
when mounting on drywall or other thin
substrate.
Position dispenser tube brackets (#2) over4.
wall brackets. Slide dispenser into wall bracket
until snug.
LOADING THE DISPENSER:
Your Modular SIMPLI-FLEX dispenser model
is completely self-adjusting and can dispense
virtually any size or shape of cup!
dispenser before use - see below.
Unwrap cups and gently push into dispenser1.
tube,
BOTTOM OF CUP FACING OUT.
®
Please clean
®
FIGURE 1.
CLEANING THE DISPENSER:
Your Modular SIMPLI-FLEX dispenser is
designed to provide an easy means of
dispensing. The dispenser can be completely
disassembled without tools to make regular
cleaning simple and painless! Regular cleaning
will prolong the life of the dispenser, keep it
looking new and ensure sanitary dispensing.
®
TO CLEAN DISPENSER:
Remove dispenser from wall or mounting
1.
location.
Remove lid (#1), clamp ring (#5), gasket (#6),
2.
spring and pusher (#7).
3.
Clean lid, clamp ring and gasket in hot, soapy
water. Air dry.
washer safe.
4.
Rinse inside of dispenser tube and wipe with a
non-toxic cleaner/sanitizer.
Exterior of tube may be cleaned with any glass5.
cleaner and a soft cloth.
6.
Reassemble dispenser in reverse of above.
MODULAR
DISPENSING SYSTEMS
DIVISION OF TOMLINSON INDUSTRIES
13700 Broadway Ave.
Cleveland Ohio 44125-1992
Phone: 216/587-3400
Fax: 216/587-0733
www.tomlinsonind.com
World Class, Worldwide
Tomlinson Industries 2002
©
Note: These parts are dish
®
FORM 1907629
PRINTED IN U.S.A.
REV. 8/02
1 of 2
O:\Cad\JME INSTRUCTION SHEETS\1907629.dwg
2 of 2
Loading...