Tomar Electronics 500L-1224-X Instruction Sheet

IS0560-02

10/25/2016

500L-1224-X

SPECIFICATIONS

SIZE 5.25” tall x 5.5” dia. x 2.0 lbs (133mm x 140mm x 0.9kg)
NEMA 4X
OPERATING TEMPERATURE -40 - +65 Degrees C
INPUT VOLTAGE RANGE 10-28 V (DC/AC)
NOMINAL INPUT VOLTAGE 12/24 V (DC/AC)
INPUT CURRENT:

DC INPUT Steady State Mode Flashing Mode
MAX MIN AVG
10VDC 486mA 1.1 A 2mA 263mA
12VDC 381mA 785mA 3mA 200mA
24VDC 194mA 385mA 7mA 98mA
28VDC 169mA 336mA 8mA 88mA

AC INPUT Steady State Mode Flashing Mode
MAX MIN AVG
10VAC 613mA 735mA 193mA 472mA
12VAC 644mA 830mA 215mA 499mA
24VAC 352mA 622mA 181mA 347mA
28VAC 320mA 549mA 174mA 314mA

LIGHT SOURCE Single white LED with a total luminous output of 347 lm

WIRE CONNECTION Red + V (DC/AC) System on, Steady State

Black – V (DC/AC) Ground
White + V (DC/AC) Flashing

IS0560-02

10/25/2016

OPERATION

To activate the unit in the PRIMARY - STEADYBURN MODE, connect the BLACK wire to –V (DC/AC) and
connect the RED wire to +V (DC/AC).
When in PRIMARY - STEADYBURN MODE, to change the unit to the SECONDARY - FLASH MODE, connect
the white wire to +V (DC/AC).

PROGRAMMING PRIMARY & SECONDARY MODES

1) Remove power from unit.

2) Connect the White wire and Red wire together.

3) Restore power to the unit and wait approximately 3 seconds until the unit flashes 3 times. Remove
the white wire only from +V (DC/AC), the unit will alternately demonstrate the Secondary - Flash
Mode and Primary - Steadyburn Mode that will be displayed during operation. The Secondary - Flash
Mode, followed by the Primary – Steadyburn Mode will be alternately demonstrated for
approximately 4 seconds each. To select the next mode of operation, tap the white wire to +V
(DC/AC). The unit will cycle to the next mode in the list below.

4) When you reach the desired mode of operation, remove power from the unit.
When power is reapplied the unit will operate as last programmed.

Mode # Steadyburn Mode Secondary - Flash Mode

1 (Factory Setting) High Single - 60 FPM
2 OFF Single - 60 FPM
3 Low Single - 60 FPM
4 High Single - 150 FPM
5 OFF Single - 150 FPM
6 Low Single - 150 FPM
7 High Single - 375 FPM
8 OFF Single - 375 FPM
9 Low Single - 375 FPM
10 High Neobe - 75 FPM
11 OFF Neobe - 75 FPM
12 Low Neobe - 75 FPM
13 High Neobe - 150 FPM
14 OFF Neobe - 150 FPM
15 Low Neobe - 150 FPM
16 High Double - 125 FPM
17 OFF Double - 125 FPM
18 Low Double - 125 FPM
19 High Double - 250 FPM
20 OFF Double - 250 FPM
21 Low Double - 250 FPM