Tomar Electronics 370L-1280-A, 390L-1280-A, 395L-1280-A Instruction Sheet

VDC MODELS

370L-1280-A Surface Mount
390L-1280-A ½" Female Pipe Mount
395L-1280-A ½" Male Thread Mount

LED FLASHING BEACON 12 / 80VDC

NEMA 4X ENCLOSURE

INSTALLATION, OPERATION AND MAINTENANCE DATA SHEET

SAFETY NOTICE WARNING

Failure to follow all safety precautions
and instructions may result in property
damage, serious injury, or death to you
or others.

SAFETY MESSAGE TO INSTALLERS,
USERS, AND MAINTENANCE PERSONNEL

It is important to follow all instructions shipped
with this product. This device is to be installed
by a trained installer who is thoroughly familiar
with the national electrical code and local codes
as well.

The selection of the mounting location for the
device, its controls and the routing of the wiring
is to be accomplished under the direction of the
facilities engineer. In addition, listed below are
some other important safety instructions and
precautions you should follow:

Read and understand all instructions before

installing or operating this equipment.

Do not connect this device to the system

when the power is turned on.

After installation, ensure that all screws and

thread joints are properly tightened.

After installation, test the system regularly to

ensure that it is operating properly.

After installation and testing is complete,
provide a copy of this instruction sheet to all
operating personnel.

The unit may be mounted in any orientation that
provides the desired illumination.
Mounting hardware and installation details are
left to the installer to provide.

WIRING

The MICROLED VDC Models are rated for
operation from 12 to 80 VDC.

OPERATION

To operate the unit, just apply power. There are
no adjustments to make for flash rate or
intensity.

SERVICE AND REPAIR

INSTALLATION

Important - Before installing, check the fixture
nameplate to be sure you have the correct
fixture for your application.

MAKE SURE THAT THE CIRCUIT IS
DEACTIVATED BEFORE STARTING THE
INSTALLATION.

Wiring shall be installed in accordance with
national and local codes.

IS0554-00

08-04-11

Should the light fail to operate, check to see that
the proper voltage is reaching the unit.

The sealed units contain electronic components
that are not accessible. Therefore, no field
repairs are possible.

Cleaning - The unit is made of Lexan
polycarbonate plastic. Use ONLY mild soap and
water to wash. DO NOT USE ANY products

containing Hydrocarbons.