Tokyo Hy-Power HL-82V Instruction Manual
•
•
•
•
•
•
•
I I I I I I I I I I I
♦ I
• ♦
IIIIIIIIIII
INSTRUCTION MANUAL
•
•
•
•
•
2
METER POWER AMP
model HL-82V
•
411
0 TOKYO NY-POWER LABS, /NC.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
* General Information
The HL-82V is a high power linear amplifier designed for
the 144MHz amateur band operation. It features a stable and
powerful amplifier along with excellent linearity which is
especially effective on SSB mode. The built in high-gain receiver
pre-amp used in the HL-82V enables you to enjoy more comfortable dX QSOs. In addition the RX pre-amp can be independently operated.
* Features
1.
Power Level Meter
Accurate output power can be read with a built-in precision
directional coupler.
2.
Low Noise MOS FET RX Pre-Amp
The latest MOS-FET with high gain and excellent cross
modulation characteristics, amplifies even a very weak
receiving signal. This preamp can be independently operated, when only receiver amplification is needed.
3.
Output Power Level Switch (HI/LO)
Output power can be reduced by one-half at the "LO"
position.
4.
FM/SSB Mode Switch
The time constant of the COX (automatic send-receive
switch) is changed in relation to the mode, in "FM", the
change from "TX" to "RX" is made instantly and in
"SSB", with some delay.
5.
Terminal for Remote Send-Receive Control
A remote control terminal is accomodated at the rear panel.
This enables a smooth and instantaneous change-over es-
pecially on SSB mode, when two leads are wired to the
remote control terminal of the transceiver.
SHORT A
GND
+ DC C'
(Usually pins A and B are used. For those radios who
produces positive DC voltage at "transmit" state, use B
and C .)
* Specifications
DC Power
Frequency
Mode
Output Power
Input Power
I nput/Output Impedance
Input/Output Connectors
Accessory Circuit
Semiconductors Used
Accessories
Dimension
Weight
: +13.8V, 13A (max)
•
144MHz amateur band
(144-148)
FM, SSB, CW
10-85W
1-12W
50 ohms
SO-239
COX (Carrier Operated T-R
Switch), RX Pre-amp, Power
Meter, Power Level switch, Reverse Polarity Protection
RF Power Transistor 1
Transistors
3
MOS FET
1
Diodes
1
15A spare fuse
1
Instruction manual,
1
•
152(W) x 92(H) x 217(L) mm
: Approx. 1.8 kg
Loading...