Tokyo Communication Equipment MFG PC1160002 User Manual

Multichannle R/W Module Specification
supports legal regulation
Since this module is not sold to general end users directly, there is no user manual of module. For the details about this module, please refer to the specification sheet of module. This module should be installed in the host device according to the interface specification (installation procedure).
The following information must be indicated on the host device of this module;
Contains Transmitter Module FCC ID: 2ACJJPC1160002 IC: 11913A-PC1160002 or Contains FCC ID: 2ACJJPC1160002
IC: 11913A-PC1160002
This device complies with
Part 15 of FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of this device.
The following statements must be described on the user manual of the host device of this module;
FCC CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.
- Properly shielded and grounded cables and connectors must be used for connection to host computers and / or peripherals in order to meet FCC emission limits.
- USB cable and Antenna Cable with ferrite core must be used for RF interference suppression.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
IC CAUTION Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
TNS12081 Rev 1.0
4
Loading...