TOENNESEN BTS-26 User Manual
1
User’s Manual
Model: BTS-26
FCC ID:2AA7L-BTS26
Bluetooth Speaker
(Splash-Proof)
This device complies with part 15 of the FCC Rules.
Operation is subject to the condition that this device
does not cause harmful interference
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
2
A. Important
Don’ts
Do not place naked flames, such as lighted candles on or near the
product.
Do not place objects filled with liquids, such as vases on or near the
product.
Do not use or store this product in a place where it is subject to direct
sunlight, heat, excessive dust or vibration.
Do not keep or store this product in wet conditions for long period.
Do not push foreign objects into the slots or holes in the product.
Do not attempt to open this product yourself. There are no user
serviceable parts inside.
Do not allow children access to plastic bags.
Safety Instructions
Before using this product, read and follow all warnings and
instructions.
This product is not intended for use by young children. Young children
should be properly supervised.
This product is intended for household use only and not for
commercial or industrial use.
No naked flame sources, such as lighted candles, should be placed on
the product.
Ventilation should not be impeded by covering ventilation openings
with items such as newspapers, table cloths, curtains and the like.
Make sure the unit is adjusted to a stable position. Damage caused by
using this product in an unstable position or by failure to follow any
other warning or precaution contained within this user manual will
not be covered by warranty.
We, suggests retaining the packaging in case for future transport of the
product.
WARNING:
Never remove the casing of this apparatus.
Never place this apparatus on the other electrical
equipment.
Caution for Splash-proof
This unit has been constructed to resist for light splashes water or light
rain. It should never be operated under running water and under no
circumstances it should never be fully immersed in water.
This unit has silicon seals cover to minimize the risk of moisture/rains
water getting inside from USB port. However, do not immerse it in
water since permanent damage to the electrical and mechanical parts
will result.
3
B. Outlook and Controls
1 2 3
4
6
5 7 8
11
10 1213
9
4
Item
Control
1
Loud Speaker
2
Built-In Bass Radiator
3
Silicon Seal Cover
4
Micro USB Socket (Under Silicon Seal Cover)
5
Mode LED Indicator (Red and Blue)
6
Button (ON / OFF, Pick up/hang up/Redial/Ignore)
7
Button (Previous, Volume down)
8
Button (Next, Volume up)
9
Button (Play / Pause, New Pairing)
10
Button (Torch light control; Light On (High)/ Light On (Mid) / Light Off)
11
MIC Hole (for Hand-Free)
12
Torch LED Light
13
Slot Foot (for bike mount bracket)
C. About the rechargeable Battery & Charging
a. Regarding the lithium rechargeable battery:
1. This device has an internal, non-user-replaceable battery. For best
results, the first time you use this Bike Bluetooth Speaker, let it
charge for about 2.5 ~ 3.5 hours or until the “Mode LED (5)”
indicator turn Off from red light which show the battery is fully
charged.
2. For maintain the battery life and performance, if device isn’t used for
a while, the battery might need to be recharged. Recharge the
battery at least once per month.
b. To recharge the built-in battery:
You can charge the Bike Bluetooth Speaker’s battery in two ways:
1. Connect it to the Computer. Or,
2. Use the USB power charger. (not included)
c. Connection and Charging:
1. Open the “Silicon Seal Cover (3)” and connects the Bike Bluetooth
Speaker’s “Micro USB Socket (4)” with the Computer’s USB port
through the USB cable.
2. The “Mode LED (5)” indicator will turn On in red light, the battery is
in charging.
3. The “Mode LED (5)” indicator will turn Off from red light when it’s
fully charged.
4. Disconnect the USB cable when it is done.
Mode LED Function for charge:
Item
Charge Mode
LED Status
1.
In Charging:
Red light On
2.
Charge Completed:
Red light Off
Loading...