Toa WM-5225, WM-5265 Instruction Manual

G02 G02
i~TOA
English:
page 1 Espanol:
pagina
Deutsch:
seite
8
<P:X:
(
~1**
):
29il[
Fran9ais:
page
CE©
INSTRUCTION MANUAL
WIRELESS MICROPHONES WM-5225
WM-5265
Thank you for purchasing TOA's Wireless Microphone. Please carefully follow the instructions
in
this manual to ensure long, trouble-free use of your equipment.
1.
SAFETY PRECAUTIONS
Be
sure to read the instructions
in
this section carefully before use.
• Make sure to observe the instructions
in
this manual as the conventions of safety symbols and messages
regarded as very important precautions are
included.
We also recommend you keep this instruction manual handy for future reference.
Safety Symbol and Message Conventions
Safety symbols and messages described below are used
in
this manual to prevent bodily injury and property
damage which
could result from mishandling. Before operating your product, read this manual first and
understand the safety
symbols and messages so you are thoroughly aware of the potential safety hazards.
~WARNING
~CAUTION
Indicates a potentially hazardous situation which,
if
mishandled, could
result
in
death or serious personal injury.
Indicates a potentially hazardous situation which,
if
mishandled, could
result
in
moderate or minor personal injury, and/or property damage.
(
__
~_!
_W_A_R_N_IN_G_~)
When the Unit
is
in
Use
• To prevent the electromagnetic wave from badly influencing
medical
equipment,
make
sure
to
switch off the unit's power when placing
it
in
close
proximity to the medical equipment.
Use
TOA's
BC-5000
Battery
Charger
when
recharging.
• The wireless microphone can be powered by WB­2000 Battery. But, if use of
any
other than the
counter specified battery into the
BC-5000 Battery
Charger,
it
may
cause
fire,
personal
injury, or environmental contamination due to battery rupture or
leakage.
The use of any other than the specified charger could
result
in
fire,
personal
injury,
or environmental contamination due to battery rupture or
leakage.
• Stop
charging,
if
the batteries are not fully charged
within 3 hours.
Failure to do so may cause the
batteries to fire,
explode, leak, or heat.
• Never short-circuit the charging terminals on the bottom of the microphone with
metal objects. Doing
so
could result
in
electric shocks or burns.
(
____
~_!
_C_AU_T_IO_N
___
)
When the Unit
is
in
Use
• When the unit
is
not
in
use for
days or more,
leakage
may
cause
personal
injury
or
contamination of environment.
Make
sure
to
observe
the
following
handling precautions so that a fire or personal injury does not
result from leakage or explosion of the battery.
· Do not
short,
disassemble,
heat
nor
put
the
battery into a fire.
· Never charge batteries of the type which are not
rechargeable. Do
not solder a battery directly.
·
Be
sure to use the specified type of battery.
TOA
Corporation
2
·
Note
correct
polarity
(positive
and
negative
orientation) when inserting a battery
in
the unit.
· Avoid locations exposed to the direct sunlight, high temperature and high humidity when storing
batteries.
Do
not place the dry cell battery into charger.
Placing non-rechargeable batteries
in
the charger
may cause the battery to crack
resulting in a fire and/or harm to the body. When recharging,
please
only
use the
BC-5000 Battery Charger and WB-2000 Battery. Do
not use other battery types.
When
the
battery
becomes
inflated
or
leaks,
discontinue
use
and
replace
with
new
one immediately. If
there's any burning and/or peculiar smell while charging the battery, please switch off the power immediately.
CAUTION TO USER: Changes or modifications not
expressly
approved by the party responsible for compliance could void the user's authority to operate the equipment.
IMPORTANT NOTE: To comply with the FCC RF
exposure
compliance requirements, no change to
the antenna or the device
is
permitted. Any change
to
the
antenna
or
the
device
could result in
the
device exceeding the
RF
exposure requirements and
void user's authority to operate the device.
License requirement
The term "IC:" before the radio certification number only
signifies
that
Industry
Canada
Technical
specifications were met. Operation
is
subject to the
following two conditions;
(1) This device may not cause
harmful interference,
and (2) this device must accept any interference
received,
including
interference
that
may
cause
undesired operation.
Le
present
appareil
est
conforme
aux
CNR d'lndustrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisee aux
deux conditions suivantes : (1)
l'appareil
doit pas
produire de
brouillage, et
(2)
l'utilisateur de l'appareil
doit accepter tout brouillage radioelectrique subi,
meme
si le
brouillage
est
susceptible
d'en
compromettre
le
fonctionnement.
2.
GENERAL DESCRIPTION
The TOA's WM-5225 Wireless Microphone employs an electret condenser microphone element of high sensitivity and
intelligible sound quality, and
is
suitable for speech use.
WM-5265
is
a vocal microphone, employing a fine, powerful dynamic microphone unit.
3. FEATURES
• One frequency can
selected from 64 frequencies (16 channels x 4 banks) of 576 - 865 MHz (576
-606
MHz
and
614 - 698 MHz for USA/Canada).
·An
optimized
PLL-synthesizer
minimizes
the
oscillation
frequency
drift
resulting from
the
ambient
temperature or voltage fluctuation.
Power/Battery lamps indicate battery consumption to prevent the unit from malfunctioning when the battery level remarkably decreases.
• Operates
a single AA battery.
• Employs a built-in antenna.
• The state of battery consumption can be displayed on the tuner's indicator when the unit is used
in
conjunction with the optional WT-5800, WT-5805 or WT-5810 Wireless Tuner.
4.
HANDLING PRECAUTIONS
Do
not expose the unit to rain or
environment where
it
may
splashed
by
water or other liquids, as
doing so may
result
in
unit failure.
Never open nor remove the unit case to modify the unit. Refer all servicing to your nearest TOA dealer.
Take care not
to
drop the unit onto the floor nor bump
it
against a hard object as the unit could fail.
Do
not place the unit
in
locations of high temperature (ex.
in
ill-ventilated car
in
summer) or high humidity
as the unit
could fail.
Do
not use the unit
in
locations where
it
is
exposed
to
seawater.
• To clean, use a dry cloth. When the unit gets very dirty, wipe lightly with a cloth damped
in
a dilute neutral
cleanser,
then wipe with a dry cloth. Never use benzine, thinner, or chemically-treated cleaning towel.
Avoid using a mobile telephone near the wireless microphone
in
use. Noise could
picked
up.
• When using two or more wireless microphones, keep them at least 50
cm
away from each other to avoid
malfunctions or noise.
• Keep the wireless microphone at least 3 m away from the receiving antenna. Using the microphone
in
close
proximity to the antenna could result
in
malfunctions or noise.
3
Loading...
+ 4 hidden pages