TOA Q-N8000LC-AM Installation Guide

② ③

INSTALLATION MANUAL

N-8000RS ADAPTER

Q-N8000LC

1. GENERAL DESCRIPTION

The Q-N8000LC is an accessory adapter for N-8000RS or N-8010RS, N-8000 Substation Interface Unit,
which converts the output signal of the interface unit into a line level audio signal or a 25V line speaker
output. It is equipped with four channel outputs with level selection switch, which allows individual level
adjustment for each channel.

2. BASIC SPECIFICATIONS

①

Front View (away from N-8000/8010RS)

Rear View (toward N-8000/8010RS)

① Slide the switch to select the output signal.

Left “SP”: Speaker Output (1W@25V)
Middle “RS”: Bypass Output (Original N-8000/8010RS signal)
Right “LN”: Line Level Output (+9dBV max.)

② 3pin removable terminal connects to a 25V speaker, RS station or mixer/amplifier.

③ 3pin removable terminal connects to the N-8000/8010RS output terminals.

Number of Channel 4 channels
Connectors Input: Eurostyle terminal connector (3pin) x4

Output: Removable terminal (3pin) x4 (Connectors are supplied with N-

8000/8010RS)
Signal Adjustment Three-position slide switch x4
Output Signal “SP”: Speaker Output (1w@25V)

“RS”:

Bypass Output (Original N-8000/8010RS signal)

“LN”: Line Level Output (+9dBV max.)
Dimensions 2.72”(w) x 1.54”(h) x 1.10”(d)* (69 x 39 x 28mm*)

*Not including output connectors.
Weight 1.09 oz (31g)

TOA Electronics, Inc.

Note:

Step2.

Step3.

Step

1.

3. INSTALLATION PROCEDURE

Set the output signal of each 4 channel using the slide switch.

(Example shown)
CH1: “SP” Speaker Output
CH2: “LN” Line level Output
CH3: “RS” Bypass Output
CH4: “RS” Bypass Output

Insert the Q-N8000LC into the terminals of the N-8000RS or N-8010RS.

When mounting on ports 1 through 4, please lift

up the cable clamp as shown below.

Wire the 3pin removable terminal plug which is supplied with N-8000/8010RS, and insert it into the

terminal block on the Q-N8000LC. The other end of this wire connects to the corresponding device.

Shield

+

+

RS Station

C
B
A

Mixer/Amplifier

25V Speaker

Note: For operation of the system, refer to the N-8000 series operating instructions. All ports should be

assigned as a substation which is compatible with N-8000/8010RS in the N-8000 setting software.

TOA Electronics, Inc.