Toa F-500WP, F-600WP-L, F-500WP-L, F-600WP Instruction Manual

SPEAKER SYSTEM

Instruction Manual

F-500WP, F-500WP-L
F-600WP, F-600WP-L

Important: READ RULE FOR SAFE INSTALLATION, OPERATION AND INSTRUCTIONS CAREFULLY.

Handlin

1. The speaker system is rainproofed for outdoor applications. However, do not dash water intentionally over unit f o r
the cleaning purpose as this can cause damage to the internal speaker components.

2. Do not loosen any fixing screws of this speaker for disassembly or modification. This impairs the speaker's rain­proof capability, involving a risk of accidents or breakdowns.

3. Sea breezes shorten the life of this speaker. Do not install the speaker in the seaside areas.

4. Toa can accept no responsibility f or accidents or unit's breakdowns resulting from improper installations or dis­assemblies or modifications performed for purposes other than legitimate maintenance or repair services.

Features

1. Rain- and weather-proof construction that makes the
speaker most ideal for outdoor applications.

2. 2-way, sealed speaker incorporating a woofer with
high power handling capacity and a constant-

directivity (CD) horn tweeter with a high-efficiency driv-

er.

3. Uniform frequency response within the range of 60°
horizontal × 40° vertical thanks to the CD horn.

4. Enclosure is made from polypropylene resin that
assures high sound performance.

5. Designed f o r high efficiency, extended range and high
durability as well as for easy installation, the speaker
can be used in wide applications.

g precautions

Specifications

F-500WP
Type ...
Woofer
Tweeter
Rated power or

Power handling capacity

Impedance

Output SPL
Frequency ...
Crossover ...
Ambient ...
Material ...
Color

Dimensions

(W×H×D)
Weight

* Rated power input ** Continuous pink noise input *** Continuous
program input

The above specifications are subject to change without notice.

452x282x210 mm

17.8x11.1x8.3 inches
Approx. 11 kg Approx. 9.5kg

F-500WP-L

20cm cone 30cm con e

CD horn + drive r

60W*

93dB (1W/1m)

80~20000Hz

80W"

240W***

3000Hz

Polypropylene resin

F-600WP

Sealed type

120W*

98dB(1W/1m)

-15°C ~ +50°C

Ivory

552×392x250 mm

21.7x15.4x9.8 inches
Approx. 20kg | Approx. 17.5kg

80~20000Hz

2000HZ

F-600WP-L

120W***

Installation

1. To avoid breakdowns, we suggest that you install the

speaker in the areas where the ambient temperature is

fr om -15°C to +50°C. In snowy areas, protect unit

from the snow.

2. When installing the speaker, use the optional mounting
bracket fo r outdoo r installation. Also, take care about

the following:

(1)The bottom surface of the speaker has two air

vents and one drain hole. Be sure to mount the
speaker with that side down, taking care that such
holes are not blocked. (The drain hole is f o r drain-

age of rainwater that enters the horn.)

1. Polarity
When connecting the speaker, observe the polarity

shown in the figure below.

2.

Impedance

switching

(Only

available

for

F-500WP

and

F-600WP)

The speaker input impedance can be switched in 4
steps with a built-in selector. See the table below.

The impedance is factory-pre s e t to position 3.

Air vent

(2 locations)

Drain hole

Bottom surface

(This side down.)

(2)As shown in the figure below, the speaker can be

positioned at any angle from 0° (horizontal) to a 45°
downward angle. As this mounting range permits

free drainage of rainwater from the inside of the

speaker, do not exceed this range, nor direct the

speaker upward.

Positioning angle

F-500WP

Position [1]
Position [21

Position [3]
Position [4]

F-600WP

Position [1]
Position [2]
Position [3]
Position [4]

100V Lin e

15W
30W

60W

100V Lin e

30W
60W

120W

70V Line

7.5W
15W

30W
60W

70V Line

15W
30W
60W

120W

Overload protection device

The speaker is provided with individual overload protec­tion devices f or woofer and tweeter. (When the woofer's
device is activated, the woofer's output signal level is

attenuated by about 15 dB, while the tweeter is cut off if

the tweeter's device is activated.) If the sound volume of
the woofer or tweeter suddenly decreases during use,
this indicates that the protection devices have leaped into
action. In such a case, lower the speaker input power
level once first to wait till the protec t io n devices automati-

cally return to the normal condition (about 2 to 20

seconds). Af te r they are reset, use the speaker turning
down the volume a little more than before.

Frequency response (1W/1m: 1/3 Octave Pink Noi se)

TOA Corporation

KOBE, JAPAN

Printed in Japan

133-01-312-20

F-500WP, F-500WP-L
F-600WP, F-600WP-L

133-01-312-20