Toa F-505WP, F-505WP-L, F-605WP-L, F-605WP Instruction Manual

Page 1
SPEAKER SYSTEM
INSTRUCTION MANUAL
F-505WP, F-505WP-L
F-605WP, F-605WP-L
Please follow the instructions in this manual to obtain the optimum results from this unit.
We also recommend that you keep this manual handy for future reference.
SAFETY PRECAUTIONS
Safety Symbol and Message Conventions
Safety symbols and messages described below are used in this manual to prevent bodily injury and property damage which could result from mishandling. Before operating you r product, read this manual first so you are thoroughly aware of the potential safety hazards as well as understand the safety symbols and messages.
Install t h e unit on ly in a l ocation that can structurally support the weight of the unit and the mounting bracket. Doing otherwise may result in t he speaker falling down and causing personal injury and/or property damage.
Should th e following irregularity be fo und during use, immediately stop operating the unit and contac t your nearest TOA dealer. Make no further attempt to operate the uni t in this condition as this may cause fire or electric shock.
If you detect smoke or a strange smell coming fro m the unit. If water or any metallic object gets into the unit If the unit falls, or the unit case breaks If it is malfunctioning (no tone sounds.)
Since installation requires specialized skills and professional experience, always consult the shop fr om where the unit was purchased before beginning installation. If the speaker should fall, it could result in electrical shocks or other personal injuries.
Do not ope rate the speaker f o r an extended period o f time with the sound distorting. This is an indication of a malfunction, which in turn can cause heat to generate and result in a fire.
Have the speaker unit checked periodically by the shop from where it was purchased. Failure to do so may result in corrosion or damage t o the speaker or its mounting bracket that could cause the speaker to fall, possibly causing personal injury.
TOA Corporation
Do not open th e inside f o r disassembly o r modification. Because the unit employs a special splashproof
construction, do not loosen nor remove screws. Failure t o observe these instructions may cause the speaker to fall, resulting in personal injuries.
Use the unit in locations where the temperature is between -15°C and +50 °C. When installing in the snowy area, take appropriate measures to prevent snow from lying on the unit. If the ambient temperature exceeds -15°C or +50 °C or if the snow lies on the unit, the speaker may fall, causing personal injuries.
WARNING
Indicates a potentially hazardous situation which, if mishandled, could result in mo derate or minor personal injury, and/or property damage.
Indicates a potentially hazardous situation wh ich, if mishandled, could result in death or serious personal injury.
CAUTION
WARNING
CAUTION
Page 2
FEATURES
Rain- and weather-proof construction that makes the speaker most ideal for outdoor applications.
2-w a y sealed speaker incorporating a woofer with high power handling capacity and a constant-directivity (CD) horn tweeter with a high-efficient driver. Uniform frequency response within the range of 60° horizontal x 40° vertical thanks to the CD horn.
Enclosure is made from polypropylene resin that assures high sound performance.
Designed for high efficiency, extended range and high durability as well as for easy installation, the speaker can be used
in wide applications.
USER PRECAUTIONS
The unit employs a splashproof construction. However, do not dash water over it purposely to clean, because its speaker element and other internal components may be damaged.
Avoid installing t h e unit near the se a because its li f e is extremely shortened when used in locations affected by a briny
air.
DIMENSIONAL DIAGRAMS
[F-505WP, F-505WP-L]
[F-605WP, F-605WP-L]
Air vent
Unit: mm
Front view
Side view
8-M8 Depth : 23 mm
Bottom view
Rear view
Side view
Rear view
Front view
Air vent
Bottom view
8-M 8 D epth : 23 mm
Page 3
INSTALLATION
When installing the speaker, use the optional mounting bracket for outdoor installation. Also, take care about the following:
The bottom surface of the speaker has two air vents. Be sure to mount the speaker with that side down, taking care that such holes are not blocked.
As shown in the figure below, the speaker can be positioned at any angle fr om 0 ° (horizontal) to a 45° downward angle. Do not exceed this range, nor direct
the speaker upward.
Caution: Avoid installing the unit near the sea because its life is extremely shortened when used in locations affected by a
briny air.
Although the unit employs a splashproof construction for permanent out door installation, the ambient operating temperature is from -15 ° C to + 5 0 °C .
When installing in the snowy area, tak e appropriate measures to prevent snow from
lying o n the unit. If the ambient temperature exceeds -15°C or +50 ° C or if the snow lies on the unit, the speaker may fall, causing personal injuries.
CONNECTION
Polarity
When connecting the speaker cables, observe the polarity shown at right.
Impedance Switching (Available for F-505WP and F-605WP)
The speaker input impedance can be switched in 4 steps with a built-in impedance selector (rotary switch).
See the table below.
Note: The impedance is factory-preset to position 3.
To switch the impedance, remove the rear-mounted water protection cap and set the impedance selector to the desired impedance using a screwdriver.
Be sur e to fi t the water protection cap in place after setting the impedance.
When connecting the speaker to 100 V line, do no t place th e impedance selector in position 4 because this can be
cause failure or breakdowns of the speaker, having the bad effect on the amplifier as well.
Cautions
F-605WP
100V Line
30W 60 W
120 W
——
70 V Line
15W 30W 60 W
120 W
Air vent
Bottom surface
(This side down.)
Horizontal
Water protection cap
Impedance selector
(F-505WP and F-605WP only)
[Rear panel]
F-505WP
100V Line
70 V Line
Within 45°
Position [1] Position [2] Position [3]
Position [4]
670 330 170
83
15 W
30
W
60 W
——
7.5 W 15 W
30
W
60 W
Position [1]
Position [2]
Position [3] Position [4]
330 170
83 42
Page 4
OVERLOAD PROTECTION DEVICE
The speaker is protected with individual overload protection devices f o r woofer and tweeter. (When the woofer's device is
activated, the woofer's output level is attenuated by about 15 dB, while the tweeter is cut off if the tweeter's device is
activated.)
If the sound volume of the woofer or tweeter suddenly decreases during use, this indicates that the related protection device has leaped into action. In such a case, minimize the amplifier's output level once first to wait till the p rote ction device automatically returns to the normal condition (about 2 to 20 seconds). After it is reset, use the speaker turning down the volume a little more than before.
SPECIFICATIONS
Enclosure Type
Woofer
Tweeter
Rated Power or
Power Handling
Capacity
Impedance
Output Sound Pressure Level
Frequency Response
Crossover Frequency
Ambient Temperature
Enclosure Material
Color
Dimensions
Weight
F-505WP
F-505WP-L
F-605WP
F-605WP-L
Sealed type
20 cm-dia cone
30 cm-dia cone
CD horn + driver
60 W
(Rated power input)
80 W
(Continuous pink noise)
240 W
(Continuous program)
120 W
(Rated power input)
120 W
(Continuous pink noise)
360 W
(Continuous program)
93 dB (1
W, 1 m)
98 dB (1 W, 1 m)
80~20,000 Hz
3,500 Hz
2,500
Hz
-15°C ~ +50°C
Polypropylene resin
Ivory
452
(w)x282(h)x210(d)mm
Approx. 10.5kg
Approx.
9kg
552
Approx.
(w) x 392 (h)
19kg
x 250 (d) mm
Approx. 16.5
kg
Note : The design and specifications are subject to change without notice for improvement.
Printed in Japan
333-01-042-40
TOA Corporation
Page 5
F-505WP, F-505WP-L
F-605WP, F-605WP-L
Page 6
[F-605WP F-605WP-L]
[F-505WP F-505WP-L]
Page 7
F-505WP
F-605WP
Page 8
F-505WP
F-505WP-L
F-605WP
F-605WP-L
333-01-041-10
TEL. 0120-108-117
Loading...