Toa F-10W (White), F-10B, F-10WM, F-10BM Instruction Manual

Please follow the instructions in this manual to obtain the optimum results from this unit.
We also recommend that you keep this manual handy for future reference.

SPEAKER SYSTEM

INSTRUCTION MANUAL

F-10W

(White)

F-10B

(Black)

F-10WM

(White)

F-10BM

(Black)

< Low impedance series >

< High impedance series >

Unit: mm

• Be sure to read the instructions in this section
carefully before use.

• Make sure to observe the instructions in this
manual as the conventions of safety symbols and
messages regarded as very important precautions
are included.

• We also recommend you keep this instruction
manual handy for future reference.

When Installing the Unit

• Install the unit only in a location that can
structurally support the weight of the unit and the
mounting bracket. Doing otherwise may result in
the speaker falling down and causing personal
injury and/or property damage.

• Because the tip of an enclosure is pointed, install
the speaker in safe locations to avoid personal
injury.

• Use mounting screws suited to the ceiling or wall
structures. If the mounting surface is not strong
enough to support the speaker weight, the speaker
may fall off, causing personal injury.

When the Unit is in Use

• Should the following irregularity be found during
use, immediately switch off the amplifier's power,
disconnect its power supply plug from the AC outlet
and contact your nearest TOA dealer. Make no
further attempt to operate the unit in this condition
as this may cause fire or electric shock.

· If you detect smoke or a strange smell coming
from the unit.

· If it is malfunctioning (no tone sounds.)

When the Unit is in Use

• Do not operate the speaker for an extended period
of time with the sound distorting. This is an
indication of a malfunction, which in turn can cause
heat to generate and result in a fire.

■ SAFETY PRECAUTIONS

WARNING

Indicates a potentially
hazardous situation which, if mishandled, could
result in death or serious personal injury.

CAUTION

Indicates a potentially
hazardous situation which, if mishandled, could
result in moderate or minor personal injury, and/or
property damage.

■ FEATURES

• Compact yet full-range, sealed type that relizes wide frequency reproduction.

• Inorganic compound resin enclosure with excellent acoustic characteristics.

• Attractive, tetrahedron design for mounting on the wall or at the corner of the room without additional
brackets.

• Three LEDs for visual effects.

■ HANDLING PRECAUTIONS

Perform impedance settings before speaker installation (F-10MW and F10BM only).

■ NOMENCLATURE

■ IMPEDANCE CHANGING (F-10WM and F-10BM only)

The speaker's impedance is preset to 2 kΩ (100 V line, 5 W) by the factory. To change the impedance, check
to confirm whether the speaker line is 100 V or 70 V, then connect the red lead wire connected to the built-in
transformer's terminal to the correspondingly-labeled terminal.

Important: When the speaker line voltage is 100 V, never use the 3 W or 5 W terminal of 70 V line as the

speaker may be damaged, resulting in amplifier malfunction.

■ INSTALLATION

● Wall or Ceiling Mounting

[Method A]

1. Bring the speaker cable through the speaker cable entry hole,

and mount the enclosure to the wall or ceiling using screws
(mounting distance: 67 mm).

Note: Use proper type of screws depending on the structure

of the wall or ceiling. (No mounting screw is supplied
with the speaker.)

Tips: If it is difficult to run the speaker cable through the cable

entry hole, either detach the attachment by removing
fixing screws or drill the enclosure from the position
marked inside the enclosure. When the attachment is
removed, fit the supplied rubber bushing in the
attachment fixing hole from outside the enclosure.

2. Connect the speaker cable to the push terminal on the

reverse side of the baffle board, then mount the baffle board
to the enclosure.
(Note the correct direction of the baffle board when mounting.
Refer to the section "Front Grille Attachment.")

3. Attach the front grille.