Toa EM-370HS-AS Instruction Manual

INSTRUCTION MANUAL
HEADSET MICROPHONE EM-370HS-AS
1. SAFETY PRECAUTION
Before installation or use, be sure to carefully read all the instructions in this section for correct and safe operation.
Be sure to follow all the precautionary in this section, which contain important handling precautions.
After reading, keep this manual handy for future reference.
Indicates potentially hazardous situation which, if mishandled, could
!
CAUTION
!
CAUTION
When the unit is not use for 10 days or more, be sure to take the battery out of the unit because battery leakage may cause personal injury or contaminent environment.
Make sure to observe the following handling precaution so that a fire or personal injury does not result from leakage or explosion of the battery:
Do not short, disassemble, heat nor put battery into a fire
result in moderate or minor personal injury, and/or property damage.
Never charge batteries of the type which are not rechargeable.
Do not solder a battery directly.
Be sure to use the specified type of battery.
Note correct polarity (positive and negative orientation) when inserting a battery in the unit.
Avoid location exposed to direct sunlight, high temperature and high humidity when storing batteries.
2. HANDLING PRECAUTION
Do not expose the unit to rain or an environment where it may be splashed by water or other liquid, as doing so may result in unit failure.
Never open nor remove the unit case to modify the unit. Refer all servicing to your nearest TOA dealer.
Do not place the unit in locations of high temperature (ex. In an unventilated car in summer) or high humidity as the unit could fail.
Do not use the unit in locations where it is exposed to seawater.
To clean, use a dry cloth. When the unit gets very dirty, wipe it lightly with a cloth damped in a dilute neutral cleanser, then wipe with a dry cloth. Never use benzene, thinner, or chemically-treated cleaning towel.
3. GENERAL DESCRIPTION
TOA EM-370HS-AS is a electret condenser microphone, feature high sensitivity and speech intelligibility. Employs headset with flexible microphone holder make it convenient to use in any speech application.
4. DIMENSIONAL AND DIAGRAMS
19
3831
10,000
89.5
HEADSET MICROPHONE model EM-370HS-AS
TOA Corporation ,Japan
MADE IN INDONESIA
Cushion
Mic Cushion
Flexible Mic Holder
[Circuit diagram]
Battery: 1.5V
Phone Plug
Cushion
Unit: mm
5. OPERATING
83.5
Battery Cover
[Battery insertion]
Open battery cover by push & slide open battery cover.
Insert a "AA" battery and make sure the polarity of the battery is correct.
To lock, slide the battery cover until it is properly lock.
[Using the microphone]
Plugs the microphone into microphone input on the amplifier. Adjust the volume control.
Place the headset hook over both ears and adjust the mic position by bending the flexible mic holder. To achieve the best sound reproduction, keep the distance of 1-2 cm between mouth & the mic.
Do not take off the mic cushion as this will create unwanted noise when it is loudly speak.
6. SPECIFICATION
Type
Directivity
Rated Impedance
Sensitivity
Frequency Response
Cable Length
Finish
Connector
Dimension
Weight
Battery Power
Note: - Design and specification is subject to change without notice for improvement.
Electret Condenser Microphone
Unidirectional
2.5 k ohms, unbalanced
-51dB (1 kHz, 0 dB = 1V/Pa)
50 Hz - 12 kHz
10 meters (10,000 mm)
Battery Case: ABS, Black ; Headset: metal, Black
1/4” unbalanced phone jack
89.5 (w) x 38 (h) x 19 (d) mm (microphone body)
142 g (without battery)
1 pc of “AA” (R6S or UM-3U)
URL : http://www.toa.com.sg/
URL : http://www.toa.com.sg/
133040000200
Loading...