Toa C-BC771PM User Manual

Thank you for purchasing TOA’s Camera Pole
Mounting Bracket.
Please carefully follow the instructions in this
manual to ensure long, trouble-free use of your
equipment.

CAMERA POLE
MOUNTING BRACKET

C-BC771PM

INSTRUCTION MANUAL

1. SAFETY PRECAUTIONS

• Be sure to read the instructions in this section carefully before use.

• Make sure to observe the instructions in this manual as the conventions of safety symbols and messages
regarded as very important precautions are included.

• We also recommend you keep this instruction manual handy for future reference.

Indicates a potentially hazardous situation which, if mishandled, could
result in death or serious personal injury.

WARNING

When Installing the Unit

• Install the unit only in a location that can structurally support the weight of the unit and the ceiling suspension
bracket. Doing otherwise may result in the unit falling down and causing personal injury and/or property
damage.

• Do not install the unit in the following locations to avoid a traffic accident or personal injury:

· Locations which block the driving of a car or somebody’s passage.

· Locations where the traffic signal or road sign is hard to be seen.

• Avoid installing or mounting the unit in unstable locations, such as on a rickety table or a slanted surface.
Doing so may result in the unit falling down and causing personal injury and/or property damage.

• Use the dedicated mounting bracket. The unit could fall off, possibly resulting in personal injuries when other
bracket than dedicated is used.

Indicates a potentially hazardous situation which, if mishandled, could
result in death or serious personal injury.

WARNING

When Installing the Unit

• Do not use any methods other than specified to mount the bracket. Extreme force is applied to the unit and
the unit could fall off, possibly resulting in personal injuries.

• Attach the safety wire to the unit. If not attached, the unit could fall off, resulting in personal injury.

• Use nuts and bolts that are appropriate for the ceiling’s or wall’s structure and composition. Failure to do so
may cause the unit to fall, resulting in material damage and possible personal injury.

• Tighten each nut and bolt securely. Ensure that the bracket has no loose joints after installation to prevent
accidents that could result in personal injury.

• Avoid installing the unit in locations exposed to sea breeze or corrosive gas. Mounts may become corroded,
eventually causing the unit to fall off, which could result in personal injury.

• Do not mount the unit in locations exposed to constant vibration. The mounting screws and/or bolts may be
loosened by excessive vibration, potentially causing the unit to fall, which could result in personal injury.

• To prevent lightning strikes, install the unit at least five meters away from a lightning rod, and yet within the
protective range (angle of 45°) of the lightning conductor. Lightning strikes may cause a fire, electric shock
or personal injury.

• When installing the unit in the snowy area, take appropriate measures to prevent snow from lying on the
unit. If the snow lies on the unit, the unit may fall, causing personal injuries.

• Be sure that at least two persons are available to install the unit. Failure to do so could result in personal
injury.

• Avoid installing the unit at heights exceeding 16 meters above the ground since the unit could be exposed to
unexpected strong winds that might cause it to fall or result in other accidents.

When the Unit is in Use

• Do not touch the unit during thunder and lightning, as this may result in electric shock.

2