TLC Datalogic Gryphon GM4100 Series, Datalogic Gryphon GD4100 Series Programming Manual

Datalogic Gryphon™

GM4100 / GD4100 Series – Programming Guide

GM4100 Syncing

When using the Gryphon™ GM4100 (wireless) series scanner, after scanning any barcode in this

document (except when advised to scan both barcodes before syncing), and before proceeding
with the scanning task, return the scanner to its base to allow the base to sync with the scanner.

During the sync process lights will flash on the scanner base. When the lights stop flashing the
sync is complete. The sync process typically completes in 10-15 seconds.

Before You Begin

Important! If the GM4100 (wireless) was previously linked to another base you must first scan

the Unlink barcode at the end of page 2.

Whether or not you needed to scan the Unlink barcode, before you begin using either model



scanner you must first scan the Interface USB Keyboard EM barcode below.

 USB Keyboard Emulator

Note: If using the GM4100 (wireless) unit, scan the Interface USB Keyboard Em. barcode

below and return the unit to the base to sync.

After the sync is complete scan the appropiate function barcode on the following pages, taking
note of the barcode’s accompanying instructions.

Interface USB Keyboard Em.

³$P,HA35,P

 Disable Carriage Return

By default, Carriage Return <CR> is enabled. This function should remain enabled if using
the scanner for circulation purposes. To use the scanner with L.S Cataloging, you may wish
to disable Carriage Return.

Note: If using the GM4100 (wireless) unit, scan the appropriate barcode before returning the

scanner to the base to sync.

Suffix = none

³$P,CLFSU0000 , P

.

 Enable Carriage Return

Suffix of CR

³ $P , CLFSU0D00 , P

Datalogic Gryphon™ GM4100 / GD4100 Series: Programming Guide – March 29, 2012

1

 Enable Codabar Scanning

Scan both barcodes below.

Note: If using the GM4100 (wireless) unit, scan both barcodes before returning the scanner to

the base to sync.

Enable Codabar

Codabar Start/Stop Transmit Disable

³$P,CCBEN01,P

’’

³ $P , CCBSS0 0 , P

 Disable / Enable Stand Mode

Scan the appropriate barcode below.

DISABLE STAND MODE

³$P,CSNRM00,P

ENABLE STAND MODE

³$P,CSNRM05,P

 Reset Scanner to Factory Default Settings

Scan the barcode below to restore your scanner to the factory default settings.

Standard Default

³$P,HA00,P

 Unlink

If the GM4100 scanner was previously linked to another base you must first scan the Unlink

barcode below.

Note: Be sure to return the unit to the base to sync.

2

Datalogic Gryphon™ GM4100 / GD4100 Series: Programming Guide – March 29, 2012