TiVo Solutions d b a TiVo CRB97 User Manual

The amber LED begins to flash slowly for 30 seconds, the flash rate shall

3) If the pairing is successful, the remote will flash the amber LED quickly

remtoe has not successfully paired with a target after 20 complete

5) To activate the pairing function in IR mode, the user will press and hold

The user can use the Global Reset command to reset all programmable keys and

buttons for approximately

key. The LED will

TiVo BLE RCU User Manual

1. Pairing Method

1) To activate the pairing function the user will press any key.

be 3 flashes every 2 seconds.

2) Local Name : TiVo_S6V_Remote

5 times.

4) If the
cycles it will exit pairing mode and
enter IR mode.

the TiVo+Back key until the amber
LED begins to flash slowly.

2. Global Reset (Unpair)

features to their original factory
settings which and also un-pair Bluetooth.
To perform the Global Reset command

1) Simultaneously press and hold the TiVo + TV Pwr
3 seconds. The red LED should turn on
and stay on.

2) Press Thumbs Down button 3 times and press the Enter
blink 3 times and shut off.

FCC Caution

§ 15.19 Labelling requirements. This device complies with part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

§ 15.21 Information to user.

Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.

PDF pdfFactory Pro www.fineprint.cn

§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

* RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.

PDF pdfFactory Pro www.fineprint.cn