Tinker & Rasor 90, 45 User Manual

CORROSION MITIGATION INSTRUMENTATION

P. O. BOX 1667 SAN BERNARDINO, CA 92402 TEL: [phone] FAX: [phone]

PRODUCT INSTRUCTIONS

MODEL 45/90 PROBE

For Use With Model PD-Receiver

The Model 45/90 Probe was introduced for use with the Model PD
Detector to provide ease of operating in pipe and cable locating, short
location in corrosion control systems, and greater tracing distances.

To operate, connect the 45/90 Probe by inserting the plug into the

receptacle labeled “Cleats” on the Receiver of the Model PD

Detector. This operation automatically disconnects the search coil in
the Receiver and the search coil of the probe is placed into the circuit.
Signals received by the search coil in the probe is amplified through
the Receiver.

Operating of the 45/90 Probe is the same as with the Model PD Receiver.
(Refer to Operating Information for the Model PD Pearson Detector). When
the search coil head is in a vertical position, a sharp “null” will mark the
center of the pipe, and when the probe head is in a horizontal position, the
pipe location is marked by a “peak” signal.

For determining depth, turn the probe using the depth angle bubble
into a 45 degree angle position and move away from the known pipe
center-line with head 90 degrees to the pipe, and when a “null” is
noted, mark the location. The distance from this location to the pipe
center-line is the depth.

NOTICE: THIS UNIT IS WATER RESISTANT.

Web: www.tinker-rasor.com E-mail: [e-mail]

– 1 –

009-248